{927} air mouse smart remote control not charging

[@LianPo-wb3mq]

I have two business projects one is to make 4mA to 20mA temperature transmitter and creating a variable frequency drive circuit from scratch I am kindly requesting assistance in both projects can I reach you so that we can discuss?

[@mussycan7289]

Selamun aleykum, do you now how i turn it on, it wil not turn on, the batterij is full,thx

[@transformateur9969]

Thank you very much Haseeb, always very interesting. Let me ask you for a video suggestion, I don't understand exactly why some repairers to find a short circuit with the diode mode, will put the red wire on the ground? If there is a short circuit, the result will be the same? Thanks in advance !

[@Versatiledani]

Thanks for sharing

[@aasaan_islam]

Another beautiful demonstration

[@HaseebElectronics]

Thank you so much 😊

[@pascalphase2556]

Very efficient, bravo !

[@muhammadishtiaq24]

Excellent thanks for sharing this informative video

[@HaseebElectronics]

So nice of you

[@almohalelaty6355]

Please 🙏 Mr hasseb . Explain the temperature sensor track of the signal in Ac pcb I mean I deadly need to know what’s happening when the temperature sensor gives a signal to the processes. How many volts get out of the sensor and where did it go ?

[@HaseebElectronics]

please check this vide kzbin.info/www/bejne/nJDYi5V-e8qCjpo

[@khanlalavlogs]

Great sharing like always, keep it up brother.

[@HaseebElectronics]

best regards

[@dlggamer7014]

A good tip, if you pour some flux there where the pins are, and just slide your soldering iron , all of them will be perfectly solder and no bridging will occur , I recommended in some other videos Amtech Flux, for these kind of operations and using hot air gun to desolder a chip and soldering it back, the flux does some magic work other than that have a good day sir and thanks for sharing your knowledge with us, much appreaciated because I learned a lot of stuff from you that I use in my work too, best regards

[@vijayakumarkumar9190]

Very nice thanks

[@HaseebElectronics]

Most welcome

[@miloradgraovac74]

❤🎉

[@nayanjagirdar8408]

👌👌👌👍

[@karanchumber566]

Mere pass ikk home theatre hai jisme lage crystal ko agar touch karte to wo work karta otherwise off rehta hai to crystal normally work kyu nhi kar raha ya human touch se kaise start le raha hai plz tell me ?

[@MuhammadYaseen-vx5hw]