In this Video I show how i was able to build a CDH 110 into a Monster motorized Bicycle engine . By adding a case reed and sleeving the cylinder.
Пікірлер: 13
@DirectCurrent4uАй бұрын
Super nice work right there my friend! Sounds real sweet!👍
@Op1zilla4 ай бұрын
I was Wondering if you where gonna put out another Video, Nice Work, An you still have a Bigger 1 to build 👽👍🏻 Sounding Good
@mobdta4254 ай бұрын
How did you make the case for the reed. I have been cutting into a 80cc one for the case reed. It does not look that clean
@Antiguaandbarbuda268843 ай бұрын
@@mobdta425 hi Mike just saw your question to witch I see no answer I have one of those cases from a cdh 110 it has a zmn100 rod the case is must thicker than the standard 80/66cc being totally honest I hope this helps you I had to pay attention to what he has it looks like he rebored the 110cc cylinder looks good
@Littleevil9975Ай бұрын
Nice build bro
@LubyaginАй бұрын
Было бы интересно посмотреть видео в формате езды от первого лица, с полноценным использованием трансмиссии, переключение передач и въезд в гору на пониженной передаче. Премного благодарствую👍🏻
@lllllsp1d3rlllll4 ай бұрын
Do u fully build those motors would u build and sell one
@kjsmolik2 ай бұрын
Smolik Perfoemance thanka you for your support. Looks like a nasty build.
@Ozzieseth5 ай бұрын
What exhaust?
@Antiguaandbarbuda268844 ай бұрын
Do you make those cylinder for sale I'm willing to purchase a 56 mm
@quiddyquid80693 ай бұрын
It's from an ms660 big bore kit (56mm)
@quiddyquid80693 ай бұрын
Ms660 has the same stroke 40mm as bt100 yd100 etc
@angelsanchez-rb4jr2 күн бұрын
Greetings! I like your project and the work on the super clutch. I would like to know if you would sell it ready to assemble.