How to change out your rusted off gas tank filler neck and hose. Thanks for watching another 10 minute job, please like and subscribe!
Пікірлер: 21
@davidsayer11669 ай бұрын
Part number to the hose?? Regualr bed?
@sanderscomplete Жыл бұрын
I had to thumbs down this video. The whole reason I even watched was to find out how to get the thing off and you fast forward it through that whole part. Thanks a lot.
@peetcee6352 жыл бұрын
Great video. Very helpful. I learned from your video. Thank you
@rubenmacovei25003 жыл бұрын
Great video. 1 question, where dose the breather hose from the new filler neck go into?
@oP01723 жыл бұрын
Can you reply to this guy smh
@rickgagne85643 жыл бұрын
@@oP0172 I bet he doesn't have a clue
@10minutejobs883 жыл бұрын
It goes to the gas tank
@jiMbo3277 Жыл бұрын
@@10minutejobs88 Can you show exactly where the breather hose connects to tank please? I blew a tire and it ripped my fuel fill tube out. I can't find a place that the breather tube would connect so I'm not sure it even has one being that it has a utility bed it might be different than stock.
@stevesmokingshack Жыл бұрын
my gas tank is same doesnt have a plase for the breather hose
@jeffreybugella-ob8zs Жыл бұрын
If you forget those clamps, just open them all the way to separating, spread the ends around whatever you're clamping, and rethread the free end into the working one.
@kennyvandenburgh71432 жыл бұрын
Did you have any issues getting the inner hose in the tank???
@10minutejobs882 жыл бұрын
Yes it was a pain! Be careful not to fold it too hard
@markknights79052 жыл бұрын
Good job on patience. Thanks too
@olenaerhardt77252 жыл бұрын
Can you use a Heat Gun (accurately of course) on a new Rubber Hose for the Filler Neck to put it on? The thing is that Filler Neck is 2-1/16" with a band 2-1/4" at the end. Fuel Tank neck is 2" with a band on the end 2-1/8". It looks like the original Fuel Neck hose was 2" (kind of unclear print on it 2"). Micrometer shows on that old hose 2" ID, but it is soft, so you can put it on. I bought a new, also 2" ID and can't fit it on that Filler Neck. Can I use 2-1/4" ID (I found one) instead of 2"? There will be clamps on both sides. Thank you for the informative film.
@lockersbullriders23773 жыл бұрын
What size hose did you use ?
@10minutejobs883 жыл бұрын
I found the OE replacement hose, parts store didn't have anything close.
@TheToastercrumbs3 жыл бұрын
Did you have to replace the hose? Or could you do just buy new fill neck and use old hose and old outer protector hose and old breather house and old ground wire?
@des98363 жыл бұрын
Where or what's site did you use to order the fleet side neck filler hose?
@10minutejobs883 жыл бұрын
I believe I got the fleetside from rock auto
@hungryflamingo26892 жыл бұрын
O Reily's had my outer hose, check them out before ordering it was $64.