AB03. How to Integrate "AXIS_CIP_DRIVE" Kinetix Servo into Ethernet/IP Network in Studio 5000

[@Student_learner_123]

I would like to reuest you about the document you used in this video to discribe about different topics - "motion-um003_-en-p_Intergrated Motion on the EthernetIP Network.pdf". Is there any site where you have uploaded this document? It will be very helpful.

[@electricalautomation]

literature.rockwellautomation.com/idc/groups/literature/documents/um/motion-um003_-en-p.pdf

[@nilsongutierresfilho6433]

Great video! You help me a lot! Please Give a tip, are you need to configure first the IP in the drive and after in the Studio? Thanks

[@electricalautomation]

You need to set the IP address to the Drive device. You can use BootIP to search the device and set the IP to the drive. Then configure this IP in the studio

[@michaelcorleone3479]

very deep detail

[@electricalautomation]

Thanks for watching!

[@vorapobautomation9760]

I have the question about axis scaling setting my load is ball screw the pitch distance is 5 mm. height 1450 mm. How should I setting the values in these subject title ? Transmission ? Actuator ? Scaling ? Travel ? Soft Travel Limits ? My load move on ball screw in vertical and use 2 axis left and right it will synchronize position and speed moving in order to press the fabric roller by tension sensor control. Which command suitable for my application to motion control between MAG and MAPC ? If use MAPC How should I setting Cam profile ?

[@electricalautomation]

Please view carefully about the motion manual of Allen Bradley. kzbin.info/www/bejne/gHSWiaiIa9Gnb5o at 17:25. It is hard to answer shortly using the comments. From my personal view, you need to figure out what is your motor one revolution doing. e.g the travel distance, how far the encoder and the actual object for one revolution of your motor.

[@manuelrc2769]

Very nice, thank you!

[@electricalautomation]

Thanks for watching!

[@israeloluwabiyi9659]

Very Helpful.

[@electricalautomation]

Thanks!