MA01. [AB Motion Control] Setup Motion Control Project and Create Virtual Axis in Studio 5000 [1/10]

[@jameserayburn]

Wonderful explainations!

[@electricalautomation]

Thanks for watching!

[@disun4152]

Thank you for the video. Can you recommend a software that can read IP address by MAC address if the controller is not brand-new, out of the box.

[@electricalautomation]

Try Siemens "PRONETA", it is a free network software

[@fernandomatiasn]

Hi, could you help me create a virtual axis from the movement of an encoder (which enters through an HSC module) and then gear it to a physical axis of a Kinetic 6000. I can't find how to modify the movement of a virtual axis other than by direct commands

[@electricalautomation]

I would recommend contacting Allen Bradley tech support for your question.

[@mekbots7607]

Hi shane : how to set motor position set just from 0 to 360 after 360 start again from 0 . thanks a lot

[@electricalautomation]

Hey, here is EAH channel, I am not shane. For your question, in other brand of motion, it is named 'modulo', for Allen Bradley, you can check rotary -> position unwind.

[@hetanhawke2354]

THANKS MR

[@electricalautomation]

Thanks!

[@demurch0]

What software edition do you need for Motion Control? Standard, full or Professionally. Thanks.

[@electricalautomation]

pls find the link literature.rockwellautomation.com/idc/groups/literature/documents/qr/9324-qr001_-en-p.pdf. I used Professional version. But FULL and PRO should be common.

[@vorapobautomation9760]

Where is the next video please ?

[@electricalautomation]

The links can be found under the video Motion Control Playlist: kzbin.info/aero/PL762SfoJC-e8NbAUQ-H7a_TOdqrlBPCw4 Allen Bradley Playlist: kzbin.info/aero/PL762SfoJC-e8Ofun9xqHGRVCVsqacTKVj