Acrylic bender machine diy

Easy to use,
with angle control, air cooled, timer and clock
Made with recycle components
plans for free to download
1drv.ms/u/s!BG...

[@MrJcasilva]

😊 perfect, very well done!

[@ahmadghalem6734]

WOW THIS IS PERFECT BEST ACRYLIC BENDER VIDEO EVER SEEN LITERALLY GOOD JOOB !!!! , i will made one like this thank you

[@prosediy_]

:) i am glad you have enjoyed. Thanks for your comment

[@pjcpjc4727]

Amazing! Congratulations.

[@prosediy_]

Thanks, i am glad you have liked

[@cryptofuture9592]

Glad to watch it

[@prosediy_]

I am glad you have enjoy it, thanks for your feedback

[@jjloop9644]

Execellent job. This power variator feed ac voltage to your heat element or it uses dc voltage to your heat element?

[@prosediy_]

Thanks for hoje feedback, this poder variator feed AC voltage.

[@jjloop9644]

@@prosediy_ Thank you

[@arieugonycana]

Excelente trabajo, enhorabuena.

[@prosediy_]

Gracias, me alegra que te haya gustado

[@arieugonycana]

Sería posible decir las medidas por favor. Gracias y un abrazo.

[@whongthai1301]

post bending 2-3mm thick acrylic it starts to stress crack after a few days.... is it because its too hot or cold ? or too short a dwell time ?

[@prosediy_]

Does your machine haver poder control?

[@prosediy_]

If yes, try less temperature. In the past i fold a lot of acrylic pieces and what i did was pre-heated with the hot air gun, try ir. Regards

[@lawrencebrazeau]

hi, nice work, thanks for the video, i built a machine similar to your design and i was making a u chanel which was 38 inches by 38 inches with a 3 inch bend at each end That turned out ok but now i am bending some 2 1/2 strips which i am bending in half to make a angel piece for my project, but the angel pieces are comming out bowed, so i am trying to figure out how to avoid the bowing each piece is about 30 inches and the bender i made can accept a 48 inch piece of plastic. Am i bending it to slow..too fast? or not cooling it down ?. like i said the big sheet turned out pretty straight but the smaller pieces are not so straight. i was thinking to use a heat gun and sandwhich the 2 1/2 inch pieces between two pieces of angel iron to straighten the bowed pieces?

[@prosediy_]

Thanks for the comment. Does your machine have power Control? Try less temp. In my machine works doing that and the redults are great. Thanks again

[@abuali4485]

👏👏👏👏👏👏

[@prosediy_]

Thanks 😃

[@quemeese]

will this also work for bending Worbla?

[@prosediy_]

Yes, this machine also bend Worbla, Just need to use less power. For bending Worbla i use low temp. and short time. Thanks for watching

[@quemeese]

@@prosediy_ thanks

[@eduardoamorim6466]

f### Awesome Hug my friend

[@prosediy_]

Thanks my friend, hug