Adapt and Power Up: Assembling Parkside teamX to Einhell Power X Adapter DIY!

[@giberz5349]

hi, I would like to make a similar adapter for parkside-teccpo and parkside-tacklife. Do I read the resistance value between negative and T on the battery? And then if I understand correctly: from the Einhell battery you only took positive and negative and then connected a resistor whose value is the one read on the parkside battery, right?

[@3dAdapteri]

10kohm between T and minus for parkside, for other it depends

[@giberz5349]

@@3dAdapteri why do you use resistance? I need to make an adapter to use parkside batteries on teccpo tools. I simply tried connecting the minus parkside to the minus teccpo, the positive to the positive and T parkside to T teccpo and it works. could I cause damage this way?

[@3dAdapteri]

@@giberz5349 ahh you are going opposite way from parkside, than probably it is not needed. For example on einhell you dont need T, it also has only plus and minus pole and it is enough to work.

[@giberz5349]

@@3dAdapteri okay! Thank you so much👍

[@kim__jong__un]

Mogu li s tim adapterom puniti parkside baterije u einhellovom punjaču i obratno?

[@3dAdapteri]

imaš video na mom kanalu parkside baterija na einhell punjaču

[@jurebrac]

Pozdrav,izmedju kontakta - i T je neki otpornik??

[@3dAdapteri]

Je, 10kohm

[@jurebrac]

@@3dAdapteri Hvala..👍

[@combeman]

Planiram napravit ovakvu kombinaciju! Molim te da mi kažeš čemu služi taj otpornik i dali je on potreban? Na einhell bateriji sam izmjerio otpor između -i T 12Kohm

[@jurebrac]

@@combeman meni radi sa 10 kohma...ako ti alat neće da radi kad spojiš samo + i - onda ti je itekako potreban!a taj otpor glumi termičku zaštitu koja kad je hladan ima taj otpor...

[@combeman]

@@jurebrac hvala na odgovoru! Ja sam mislio samo spojit +na+ - na - i T na T. Šta mislis bi tako radilo ili da napravim ovako kao ti sa otpornikom?

[@xchi113rb0yx]

Stl ?

[@IhuntDoru]

La multi ani vreau un adaptor paracsayd la ferixs

[@lukalukic354]

Koliko košta da napraviš jedan adapter ovaj?

[@3dAdapteri]

Javi se na mail, imas u detaljima kanala

[@lukalukic354]

@@3dAdapteri pošalji ovde svoj e-mail nemogu da nađem gdje se to nalazi

[@djadam2766]

It's easier to use a charger as the afpater already made I completely nodded my grinder with charger adapter to take einhell battery's, Parkside battery's are crap the cells are useless, my grinder with einhell battery runs great no cutting out loads of power and even if I push hard it does not stop, shame Parkside let themselves down by making crap battery's for there tools, there good tools well built