Adjusting Draw stops on bowtech Reckoning with Justo

[@olehemlock]

This a awesome tool. Not just for syncing the Reckoning Gen 1 cams. Can use it to take measurement on single cam bows when you have to remove the draw stop to press it.

[@RGunth]

Sweet tool! Going to order one now along with the Reckoning Lucky-Stops.

[@TheSpeyfisher]

I have the new revolt-xl. It doesn't have a slide on the came? So you can't use your tool? Thanks

[@luckystops]

Hello, For the Revolt XL to adjust let-off you would use our AR and BR stops. Here is a link to the video for the stops kzbin.info/www/bejne/qoSbf5qEjJunjMU and here is a video showing how the stops work. kzbin.info/www/bejne/e53KloNjqJuLj7c Fell free to email me any questions you may still have.

[@brianhorton1721]

How will that tool work with the Bomar stops

[@luckystops]

It won't.

[@dougbarabe7861]

how do I increase holding weight and keep the same draw ???

[@luckystops]

To increase holding weight you need to move the stops forward and as you know this decreases the draw length at the same time. To regain the draw length back to what you had you need to add twists to the cables retarding the initial cam setting, this will work for adding up to about 3/8" draw. This will also increase the max poundage so you will need to back your limb bolts out a bit to correct that. If you added a lot of holding weight and moved the stop around the 1/2" of draw length, you can rotate the module to the next 1/2" longer draw length position and move the stops back to the original position and then fine tune the length with the cables again. Example: your shooting 29" and have advanced the stops to about the 28 1/2" position and like the holding weight but draw is way to short. Move the module to 29 1/2" and the stops back to 29", fine tune your holding weight your stops, you will still be around the 29" position. Now fine tune your draw length with the cables (advancing or retarding the cams) and readjust the holding weight. Typically you will have a but of wiggle room to adjust the stops to micro tune the draw length without affecting the holding weight once this is done Hope this helps, Brian

[@dougbarabe7861]

@@luckystops thank you ,,, so far the bowtech 35 , is very nice ,,,,first time in 40 years I switched from Mathews ,,,, , ,,,

[@ultimatejay]

Will this tool work for a Prime Black 9?

[@luckystops]

Yes it will, you will need the narrower pin to fit between the cams. Pin lucky-stops.com/product-category/prime-archery/