Adjusting flame on Fulgor Milano Pro Range

This video shows how to adjust the inner and outer flames of the Fulgor Milano gas cooktop burners on the Sofia ranges and range tops.

[@suzinmoon8727]

My outer ring on the dual flame burner does not light. What would be the issue. It is an LP conversion and was only installed today.

[@thevettagroupsfulgormilano9114]

It's possible whoever did the conversion missed a step (or two). There are two injectors / orifices for each burner, sometimes they either only do one of them or they get them switched by mistake. Or perhaps they neglected to close the low flame adjustment screws. Make sure you are keeping the knob on high setting when igniting.

[@angiekojonen1580]

We have 3 burners that are working great and adjusted perfect but 3 wont adjust the inner screw(for the out ring) wont budge at all. Any suggestions?

[@thevettagroupsfulgormilano9114]

If it's never been previously adjusted and you're going to 'force' it, do so while turning counter-clockwise ie. opening it...it's typically preset at about 270 degrees from closed from the factory for natural gas. Sometimes I've gotten my screwdriver beside the screw instead of in the slot of the screw in which case it feels like your engaged but you're really not and it feels like it won't turn...

[@U2GuitarLessons]

I have this new stove. Oven working but I can’t light burners. The spark plugs just keep clicking and nothing ignited on all 6 burners. What do I check for?

[@thevettagroupsfulgormilano9114]

Hi Michael. Is your range a dual fuel (electric oven) or all gas? I suspect dual fuel since if your surface burners aren't getting gas it is unlikely that your oven burners would work. I suggest checking that the gas valve is in fact turned on and then confirm that the regulator is installed correctly. It can only go in one direction and there is an arrow on it that indicates the direction of gas flow. Installing it backwards will cause the issue you are experiencing. Hope this helps.

[@omaralkhatib3000]

So my outter burner does not work. Any idea

[@thevettagroupsfulgormilano9114]

LP conversion?

[@suzinmoon8727]

@thevettagroupsfulgormilano9114 I have this same issue it is an LP conversion and the outer ring does nothing and the inner ring is very hot and high. What can I do? It was just installed today.