Adjustments for tuning the Propel X4s

[@gasbeing]

Thank you so much for this video. It totally educated me on the adjustments. Thank you!

[@justinjustintheman8816]

i cant wait for the endeavor video

[@bobperry6088]

Good job Russ

[@kawaironia1424]

Can you make a video on changing the belts on the x4s please.

[@kthocken]

Yes I’d like to see this as well

[@propelvirtualgarage963]

kzbin.info/www/bejne/rZOXhaSdjLiVrbM

[@kthocken]

Thank you. That is for the hubs for X4S not the belt. Is belt the same way?

[@replugged276]

Where can I get the white handlebars that can be seen at the bottom board at 4:40 ?

[@kthocken]

Can you make a video or a link to the Guide to the belt change?

[@propelvirtualgarage963]

kzbin.info/www/bejne/j6TJm4qrjLRshtE

[@philcantuay946]

@@propelvirtualgarage963 this video actually doesn't show the belt change or tension. Is there any videos on this? Thank you

[@propelvirtualgarage963]

@@philcantuay946 Yes, In this one Phil kzbin.info/www/bejne/rZOXhaSdjLiVrbM

[@benjaminblindert8260]

One of my motors blew out after one use and I can't reach the cord. It's buried in there. How do I unplug the cord on the propel X4S motor?

[@propelvirtualgarage963]

You take the deck off to start, thats how you access the internals but how did you diagnose that you had a bad motor?

[@benjaminblindert8260]

@@propelvirtualgarage963 I just rotated it. I can feel the binding. Took it off the belt to see which part it was. There's slight pressure when rotating like I can feel the wire rubbing or something. Thanks for the help

[@gasbeing]

The tires say "inflate to 50 psi" which is what I did. It feels pretty hard. Do you have any hints on tuning the tires?

[@propelvirtualgarage963]

I personally take 10 lbs out if Im offroad all day but ride them right at 50 on the street

[@abelgabriel4102]

can you make a video how to change the cs battery 🙏 🙏 🙏 🙏 🙏

[@propelvirtualgarage963]

cs battery?

[@abelgabriel4102]

@@propelvirtualgarage963 yes

[@davidcauson7008]

Do the castle nuts on the axles have to be tightened all the way? When I do this I can't get the split pin through, and if I loosen it a bit so the split pin goes through then the wheels are a bit wobbly.

[@propelvirtualgarage963]

They should be more than tight enough not to wobble. If you could send e a video, that would help me troubleshoot it. Send to [e-mail]

[@gregbrowne2491]

Mine does the same and they are tight, well i thought they where, it's my next trouble shoot

[@propelvirtualgarage963]

@@gregbrowne2491 Accept friend request on FB, I want to chat with you and Dave together

[@propelvirtualgarage963]

Also. Some times you need 2 washers to get it lined up properly. I should have mentioned that earlier