Air box removal - Triumph Speed Triple 2011 - 2015

Motorbike Maintenance, DIY service
Air box removal on 2014 speed triple 1050.

[@zareff]

Aligning the the rubber seals for the trumpets to the throttle bodies was a royal pain the ass on mine. Looking forward to your balancing and refitment video.

[@notamotorbikemechanic]

Sometimes you'll find it's more difficult to refit, if the rubbers are cool. This makes them hard, heat them up with a heat gun or hair dryer.

[@Matua01]

Damn that was priceless information. Thank you so much.

[@notamotorbikemechanic]

Happy to help, please subscribe & share 👍🏍

[@Matua01]

@@notamotorbikemechanic just subscribed braddah.

[@sv4792]

Thanks, very helpful, maybe you could say how could i make key with immo without diller - i bought motorcycle like this without key

[@notamotorbikemechanic]

If you need a new key, you could remove the ignition barrel and there might be a key number on it? Or contact your dealer they might be able to supply one, if you give chassis number etc. If you have the original hand books, the key number might be in there.👍

[@adrianooliveira4709]

Tem m ajuda na manutenção da minha 👍👍👍

[@notamotorbikemechanic]

De nada 👍🏼

[@anilpise979]

How many km run we need to replace or clean spark plugs and clean throttle body my speed very less use any suggestions

[@notamotorbikemechanic]

Hi, check (clean and gap) spark plugs at 10,000km. Replace at 20,000km. Throttle balance every 10,000km. Take care.

[@anilpise979]

@@notamotorbikemechanic thanks

[@MRFANTASTIC68]

Getting it off is fine, putting it back on again is a nightmare 👎

[@notamotorbikemechanic]

Just make sure the air intake, at the front of the air box is lined up properly. should be easy enough, might need a little wiggle.

[@MRFANTASTIC68]

@@notamotorbikemechanic just sorted it now, warmed the rubbers that fit on the throttle bodies with an hairdryer 😂 and made it slightly easier and abit of a wiggle popped back on 👍.