AIR COMPRESSOR PRESSURE SWITCH - How to Assemble, Replace, Wire & Adjust

How to Assemble, Replace, Wire & Adjust an Air Compressor Pressure Switch. You will walk through the whole process of how I discover where an air leak is coming from. After that I take the pressure control switch apart, repair it and then replace it back on the air compressor. Then wire both the power line and motor to the air compressor pressure control switch and make sure it is properly adjusted to come on at 85 psi and shut off at 115 psi (pounds per square inch) of pressure.
After watching this video I think you will be well equipped to diagnose, replace, adjust and repair most anything related to your air compressor pressure switch.
#aircompressor #aircompressorrepair #aircompressors
*If this video was a help to you give it a "thumbs up". If you have not already done so, please consider subscribing to this channel.
Disclaimer:
Although I have been following these procedures for many years; I assume no liability for any damage that may occur to any person or property as a result of the information provided in this video. I take necessary precautions (that I am aware of) when working on these projects but that in no way implies or creates any expressed or implied warranty or guarantee of any kind of particular result. Any injury, damage or loss of any kind to anyone or their property or anything related to information in this video is the sole responsibility of the user and not Helping U Online (this video).

[@bjacker7019]

How glad I am somebody old-school fixer like me decided to make this video! I took my shutoff apart and aghast as parts flew everywhere! I couldn't figure out where the trip spring went!! And had no idea how hard it is to re-assemble! Thanks a million as they say!

[@helpinguonline]

Glad I could help

[@angelgkd]

Great video. Couldn’t have done it without it. I just did not see the on/off lever being put in…

[@SwanDude33]

Exactly what I needed, thank you so much 👍👍👍

[@helpinguonline]

You're welcome!

[@JerryMcFall]

Loved your video. My only suggestion would be to back off the adjustment screw 5 turns before taking apart at the beginning. It just might prevent the explosion of parts at the beginning.

[@livingroompickersclub6358]

OOPS...At 12:15 while cutting the zip tie he says uh-oh because he knows that that metal piece with the wings on it has just popped out. And that's because when you cut the zip tie the tension on that metal piece with the wings on it went to zero and it popped out.

[@FourthWayRanch]

How is it connected to the motor, it looks like someone disconnected something on mine

[@AndréTraversy-p4r]

Tanks

[@helpinguonline]

Your welcome