Alfa Romeo Giulietta Heater Blower Removal and Refit, PART2 Question Answering and Diagnosis

[@rushyboy]

I've just replaced the fan/blower in my wife's Giulietta thanks to your videos and also Cran Swil. I found getting the old fan out and the replacement in was very hard because of the tight space. Also re-joining the plastic cover onto the fan in that confined space was incredibly hard. However perseverance paid off and I finally got everything back together. The whole thing took me about 7 hours over 2 days and when I turned the fan on it runs well up to half speed then it starts to make a loud vibrating noise like cardboard in a bicycle wheel. I may have damaged a fan blade during the install but I'm not going to take it back out to see. Anyway I have saved £800 which is what I was quoted for labour to remove the dash and fit the fan, so big thanks to your video and also to Cran Swil.

[@williambilverstone5576]

Wow little mechanic you have done it again!!

[@keenabog]

Excellent video and very useful. One anomaly I would love you to clear up. In the video you say that there is a constant 12 volt feed to the fan so that is how you could tell that the fan had gone. Surely the voltage feed would be variable from say about 3 volts up to 12 volts depending on the switch position? I ask because I have a problem with my fan that is not working and has a 12 volt feed with no variance. thanks, Mark.

[@atlasguiseppe3821]

bonne continuation

[@markanthony284]

Well that answers my previous question ....you did do a follow up ! ..... great explanation, everything explained in clear easy layman terms, including other common heater / blower faults on the Giulietta ....as usual great stuff, 5 ***** You Tuber.

[@mechanic5069]

Great video. My G has heating problem slightly different. When I select hot air on driver side dial/ vents say 26 deegree it does blow warm air only surely not jot, however passanger side temp/vents also selected on 26 blows they blow ice cold. Would it be mixer motors or something else, if so are they built in within whole blower motor assembly or could be removed a bit easier? Thanks in advance.

[@TheShaki98]

My FM signal has gone in my giulie too, it'll be good to see you change that antenna as mines gonna need doing. Great video btw.

[@TheShaki98]

I've done it, went through the rear courtesy light with a 1/4" rachet and extension with a 22mm socket. 30 mins tops to change!

[@JV8391]

any advice on getting to the mixer motors?

[@marknewcombe2608]

thanks for video gave me the confidence to do mine .