Alias Tips and Tricks 12 - How to Make a Wheel Flat

[@kzeeso]

Thankyou brother! This is the best way I have ever seen to make a wheel flat. And thanks for showing how to add the crown too. Easy and super clean geometry! You rock

[@3DDesignAcademy]

Thank you very much!

[@targaryen2077]

I like this method a lot more. Seems cleaner too!

[@3DDesignAcademy]

I agree. However, I did try this on other wheel flats, and there were few times that I needed to add more spans. Still cleaner than the previous method.

[@snotabe]

Thanks I really appreciate these videos, easy to follow and I learn a lot each time.

[@3DDesignAcademy]

Thank you!

[@borazeytunlu963]

Thanks 💯👌🏻

[@3DDesignAcademy]

No problem!

[@fabianopiovan6734]

Why don’t you project a curve instead of a CoS+fit curve? Is there an advantage doing it that way?

[@3DDesignAcademy]

That works too. I could project a curve, but with the Cos and fit curve, I can adjust the CV structure as needed. Also, I found that project curve takes a bit of time calculate. In the end, as long as you get a clean result, that's what matters.