Align Boring vs Align Honing (2021-22 - Episode 2)

[@terrysibley9636]

Excellent, explanation. My mind has been eased.

[@mikeVoycey]

Should an Aluminum Block with Aluminum caps be lined honed at a specific ambient temperature?

[@beachboardfan9544]

What if your mains spacing is too narrow to fit that 90 degree head?

[@thatguywillt]

Exactly what I'm curious about. Blocks like Nissan RB, Toyota 2J, maybe Jaguar 3.8 and 4.2, etc.

[@JonBanquer]

I fail to see where this machine is the way to go for exactly the reason you both mention... not enough clearance. All the manual commercial machines I've seen use a bar and a toolbit attached to the bar. This machine is a vertical machining center. I think it should be a horizontal machining center.

[@samspade4356]

66 camaro ?

[@michaelfarrell6448]

I sand my main caps on a belt sander is that bad??