Good to learn from you about the horn speakers, please more
@Diy_enjoyment6 ай бұрын
Thank you. Stay tuned.
@CollectiveIntelligenceMusic6 ай бұрын
Great videos mate. Keep em coming
@Diy_enjoyment6 ай бұрын
Thanks 👍
@eliaswiedner96958 ай бұрын
Pls more Videos about Horns. So besides the directivity control the Horn also brings a gain in sensitivity right? The transmission between driver and air gets better i think. Now are there any other Advantages?
@Diy_enjoyment8 ай бұрын
Thanks for your comment. Stay tuned for more videos.
@naturalverities3 ай бұрын
Lower harmonic distortion is another important advantage, as is a greater dynamic range before thermal compression becomes significant.
@naomispirit-evokingemotion22675 ай бұрын
I'm not getting the same excel calculation results for "Radius (M), would you mind sharing the formula
@Diy_enjoyment5 ай бұрын
Hey. The formula to get the "radius" is to divide the "Growing" values in every step by Pi then take a square root: (growing/pi)^0.5
@naomispirit-evokingemotion22675 ай бұрын
@@Diy_enjoyment Thank you for your reply =) Does Krm value imply on all the horn designs, for better determining the horn size/cut-off frequency? thanks
@kiyaggadaniel88317 ай бұрын
talk about the synagy horns
@timtom5015Ай бұрын
Hello. Why did you choose a cell with a circumference of 5.35 m rather than 4.6 m? For 4.6 m Krm is already 1,006.
@Diy_enjoymentАй бұрын
It's better to choose the "krm" more than 1. You can try different values.
@timtom5015Ай бұрын
I read that for a low-frequency horn, Krm is better to choose from 0.7 to 1.0. For MF-HF from 1.0 and slightly more than 1.0.
@Diy_enjoymentАй бұрын
The goal is a flat frequency response. Try different values please and get your own results.
@timtom5015Ай бұрын
Fine. I liked the videos you made. I watched almost everything. Thank you. Continue. Good luck.
@sc0or7 ай бұрын
Hm.. Exponential horns for high frequencies must not exist, cause their m is huuuuge. 38 for 1k (and 380 for 10k). So, exp(3.8 or 38 or 380) are unbelievable numbers
@Diy_enjoyment7 ай бұрын
If you select the cutoff frequency around 1khz it won't mean its directivity starts at this frequency you should select a lower one and its expansion will be slower for the lower radius of a driver.
@sc0or7 ай бұрын
@@Diy_enjoyment I'd like to have a minimal "horn effect" with an exponential horn type, but as I can see this type of horns is for low freqs only