Allen Bradley Powerflex 523/525, remote control, 2 Wire control, 3 Wire control. (English)

[@NorthAlabamaOutdoors]

Installed a few of these drives in the past few months, your videos would’ve been really helpful before hand, but they still help me understand a couple things better. Thanks for sharing the info!

[@jimmusgrave611]

@IGS Electronics Great video! I have a question.... If I wanted to control an AB 523 start/ stop and speed from the keypad, but also have a photoeye ( 2 wire or 3 wire) down stream that would stop the drive when blocked, and restart the drive when cleared, is that possible? Thank you

[@pradeep12ful]

can you explain the power wiring as well. I am bit confuse as my powerflex has single phase input and three phase out but I don't have the three phase load to test. How I can test with single phase load????

[@xsterawesome]

Your comment is so old you probably already figured it out, but you you should be able to hook up the single phase side, then run it as normal without a motor attached. You should be able to measure your three phase voltage across the terminals for the motor.

[@TheMahali]

can u share a setting for speed increase/decrease through dedicated pushbutton in panel. Speed raise/lower push button connected in 5th and 6th TB.

[@IGSElectronics]

There is third video of this.