This was very helpful , thanks a lot. I just would like to meet the responsible engeneer to kick bis as..
@garyoncaravanning76083 жыл бұрын
Cheers! Just used your video to change the one on my daughters car. Very helpful
@christophemontheil49333 жыл бұрын
thank you so much from France for this clip.Very usefull !!!
@TheHappysacker4 ай бұрын
Thanks for the time you put in to this.
@gilly514492 жыл бұрын
Brilliant mate thank you so much for this video 👍😁 massive help
@TheBurnoutdeluxe6 жыл бұрын
Hey dude, nice how to... But you forgott to mention that the front bolts of the arms should be tightened at driving hight of the car, so the bushings will last 10 times longer ;)
@ALLTHINGSJIM6 жыл бұрын
That is very true, I do mention to do that in my other lower arm videos, thanks for pointing that out👍
@moshazza5684 Жыл бұрын
What are the torque specs for the 2 main bolts on control arm and the pinch bolt on the ball joint thanks
@wholebarto6 жыл бұрын
Yesterday I did in my Fiat 500. It took me about 4 hours and saved some money and, as a result, all knocks and different noises went away. I had a problem with washer reservior bolts which were corroded and broke while unscrewing them.
@stdavidboy Жыл бұрын
Fiats never change, little rotters !
@BeerboxRider6 жыл бұрын
Hi, nice video! It helped me a lot. But how did you get the arm out without removing the stabilizator? It’s blocking me from pulling it out :(. I’d be grateful for some advice :)
@DerGolf20003 жыл бұрын
Loosen the link on the opposite side also....then you can move it out of the way...
@thefunnyclubkids55182 жыл бұрын
What exact tools do I need for this please? Sizes etc? Thank you
@thefunnyclubkids55182 жыл бұрын
What exact tools do I need for this please?
@071624 жыл бұрын
Can anybody tell me the Nm for all of those Screws
@mackingj65006 жыл бұрын
Removing the water bottle not needed neither do you nee to remover the cross member to do this, yeah it gives you more room but unnecessary
@jerome_karxx6 жыл бұрын
thanks !
@ALLTHINGSJIM6 жыл бұрын
Not a problem, thanks for commenting!
@jerome_karxx6 жыл бұрын
ALL THINGS JIM , good job, i will try to do it this Week, and after the timing belt , if you can post a video :-)
@ALLTHINGSJIM6 жыл бұрын
jerome karxx no problem, subscribe! Look down my videos list there is already a cambelt replacement video for this engine ;-)
@jerome_karxx6 жыл бұрын
ALL THINGS JIM ok super ! I will save Time ..
@Bakersvill2 жыл бұрын
Do you seriously have to take half the car apart for that!
@ALLTHINGSJIM2 жыл бұрын
Yes, its a pants design! 👍
@stdavidboy Жыл бұрын
I couldn't believe it either!!! Pathetic design
@carlsherwin5557 Жыл бұрын
@@ALLTHINGSJIM best place for fiat's is the scrap yard😁