Analyzing Vertical Clearance using Autodesk Vehicle Tracking - Pt. 2 of 2

[@shaunwright3719]

Used this tutorial to check some raised concrete pedestrian crossings I'm designing. Helped a lot. Thanks Jeff!

[@appmania2180]

Great tutorial series Jeff I watched all of them and learned quite a lot! Thanks again!

[@imranhamblin2125]

Great tutorial. how to I get the ground clearance key up??

[@rodrigocofrebravo5596]

Hi, great video. But I can't see the height table in my vertical analysis I'm currently using VT2025 Could you help me? Thank you very much.

[@Benbildow]

Hi everybody, how can i visualize the section created by the the analysis ?

[@andresjuarez3129]

Same question

[@imranhamblin2125]

@@andresjuarez3129 same

[@josejuanlamastacoronte3425]

Hi Jeff, thank you for the video very instructive. is it possible to modify the vehicle ground clearance without re-running the SPA?

[@GracioPermata]

Awesome tutorial. Is there a way where you can change the clearing warning symbol to different colour? instead of yellow?

[@wipsinstitute]

Superb Dear Sir may Allah Bless you

[@laurytamejia8039]

Thank you very much Jeff for the videos of Vehicle Tracking they are very useful for me. I have a question. Is the vehicle you are driving in this exercise from the Civil3D library or have you created it? This vehicle is exactly what I need for my exercise and, in addition to this, I must analyze the vehicle in a tunnel. Is there a way to make a report of vehicle collisions with the walls and ceiling of the tunnel?

[@mattheewmartiin]

Hi I am trying to create ground conflict report using C3D 2018 and VT 2018, however it will only produce the sections showing where the ground conflict is. The line/hatch in the model showing the ground proximity wont show. i have cheek through all of the reports to ensure that it is not turned off with no results. Any ideas?

[@stefanjohns2545]

If the vertical clearance is more than 100 mm then no line/hatch colouring will appear on screen. The coloured vertical ranges that may appear on screen are: 50 to 100 mm clearance = green; 0 to 50 mm clearance = yellow; 0 to 50 mm ground penetration = orange; 50 to 100 mm ground penetration = magenta; over 100 mm ground penetration = red

[@micbim1]

Excelent!

[@jdjb4396]

Great! I wish this was in spanish too. Haha thanks