Anchor install FAIL!

So I attempted to start a new Anchor trolly. And well, I’ll just look at this as a learning lesson. Would LOVE some feedback on this one. But I DID get to try out my new GoPro! #bonafidekayaks #bassfishing #bonafide #boonedox #faceyourfears #fishing #kayakangler #nrs #pfd #yakgadget #RvR #failure

[@RamonOutdoors]

I have a quick release right on my chair that connects to my anchor incase I need to quickly get free. Safest way to do a quick disconnect.

[@wolf_of_walmart]

Love this idea! Thanks for the link too bud!

[@duanebledsoe7566]

Instead of clipping to that D ring directly, I’ve read that it is better to run a line from the anchor, or floating anchor buoy, through the D ring, and secure it to the kayak within reach using a highwayman’s hitch knot. This knot provides for a quick release, much faster than you could pull the D ring back to you and then release. Sometimes you don’t have extra seconds to waste. You can still use the anchor trolley the same way as normal. The line will leave the kayak and go to the anchor still the same, and the D ring position controls where that point is on the kayak. If you need to disconnect in a hurry, simply pull the knot and it falls out and the line goes through the D ring and you’re free. The anchor buoy will float and keep the line up so you can retrieve it afterwards. Also, silicone isn’t going to work well to seal holes. Kayaks are made of polyethylene and almost nothing sticks to it permanently. You might try Lexel (another caulk). That stuff sticks to everything, I haven’t tried it on kayaks though). It even sticks to wet surfaces.

[@wolf_of_walmart]

It’s crazy you said that! I just used lexel on my latest build! And thanks for the knot idea dude.

[@MattHayesRVA]

Look up some videos on the rigging bullets from yak attack and diy versions of them. A nut and string will pull the backing plates into position. For the pulleys, they go horizontally. Closed end toward bow and stern, pulley towards the middle. Will fit in the middle of that side wall.

[@wolf_of_walmart]

I totally found this out the next day! 🤦🏻‍♂️ and thank you!

[@piesquared1025]

I do rivers. I run 2 anchors front and back. Hold off on that install, and think it over a bit.

[@wolf_of_walmart]

Thanks man🫡

[@piesquared1025]

I forgot to mention I went with a lift and lock. Meaning the lock is right at the pulley. This will leave you options to take up the loose rope. The reason in went with 2 is wind and kayak placement.

[@wolf_of_walmart]

@@piesquared1025yes! I was thinking 2 anchors! Makes me re think my whole build, but that’s the fun part! Ya know?

[@merlecarey2392]

😎 Promo`SM