ANENG SZ305 1000VDC,750VAC 2000COUNTS MULTIMETER,made in china.

[@apn1384]

Thanks for the very detailed test! Special thanks for disassembling and showing the internal contents!

[@wilsonluilui]

thx for watching

[@luizmello7020]

Obrigado pelo teste completo senhor Wilson 😃

[@wilsonluilui]

thx for watching❤

[@luizmello7020]

Hello Mr. Wilson, can you tell me if this ANENG SZ305 model reads in TRUE RMS?

[@wilsonluilui]

@@luizmello7020 you must make caculate by Vmax X 0.707

[@wilsonluilui]

or choice aneng 616.it true rms not use to any calculated.

[@luizmello7020]

I'm thinking about the low cost option SZ304...do you think I can trust ?

[@_BestFriend]

проверка ёмкости до 20mF - шикарно. Спасибо за обзор и тесты. Успехов!

[@wilsonluilui]

thx for watching.

[@antonimouszr7310]

Thk sir, Your explanation is very professional

[@wilsonluilui]

@@antonimouszr7310 THX FOR WATCHING

[@druid970]

I have sz305 voltage mode - resistance = 9.8M ohm on red and black probe battery test mode - resistance = 500ohm on red and black probe battery test mode 12v-maximum to test up to 20v your video clip perfect to reviews thank you.

[@wilsonluilui]

thx for watching sir.

[@Gamersfanko]

Thanks, very good!

[@wilsonluilui]

thx for watching.

[@sardarrahatul4687]

Hi Wilson. Which one is better aneng 616 vs aneng 620 ?????

[@wilsonluilui]

🙏

[@pault6533]

Appears there are large holes for a proper shunt wire to be soldered, but they tried to save money. Instead of this wire they put a 10 milliohm resistor between 10A input and common and put a note on the front of the unit maximum 10 seconds. However, no warming in the manual. Time to lubricate that selector wheel. It's so dry, and the spring arms really get driven down into the crests of the case. They will break prematurely without grease. With no white mark on the selector indicator, you don't know which way the wheel is turned at a glance, could result in wrong range. They also forgot to install the transistor receptacle. I will be very difficult to get the transistor wires to all three touch the PCB.

[@wilsonluilui]

it company mistake or save their money,make a low prices multimeter,😕

[@ឆ្កេចចក]

50hz?

[@wilsonluilui]

@@ឆ្កេចចក Hongkong frequency is 50 hz

[@Ajaya6991]

Mr, Review Aneng M117

[@wilsonluilui]

@@Ajaya6991 No sir we get ill and no any video come .😂

[@Ajaya6991]

@@wilsonluilui oh no? hope you get well soon from your illness,sir.

[@hoangviet8005]

The circuit board is too sketchy

[@wilsonluilui]

thx for watching,it aneng design circuit for an low prices meter.

[@danialtun5431]

This multimeter is no fuse

[@wilsonluilui]

yes,no fuse ,in mA only have resistor for protection,and other is a PTC ,IT MUST BE BROKEN meter main IC if you wrong testing in current position. before i burned three of this type meter be careful.

[@sardarrahatul4687]

Hi Wilson. Which one is better aneng 616 vs aneng 620 ?????

[@wilsonluilui]

620A aneng is easy to buy the testing pen.and 616 is hard to buy the test pen .sir