Anfim Caimano / Super Caimano | Doser service

WARNING:
The instructions shown in this video are meant to support qualified technicians and trained staff, only. Only parts that comply with the original appliance specification may be used for repairs. Mistakes in opening or assembling the machine may cause injuries and/or damages and malfunctions.
If the machine gets opened by an un-authorized person, the manufacturer’s liability and warranty expire.
WARNUNG:
Die in diesem Video dargestellte Anleitung richtet sich ausschließlich an qualifizierte Techniker und geschultes Fachpersonal. Fehler beim Öffnen oder Montieren der Maschine können zu Verletzungen und/oder Beschädigungen und Fehlfunktionen führen. Bei Reparaturen dürfen nur Teile verwendet werden, die den ursprünglichen Gerätedaten entsprechen.
Mit dem Öffnen der Maschine durch eine nicht autorisierte Person, erlöschen die Haftungs- und Garantieansprüche gegenüber dem Hersteller.
Hemro International AG
Länggenstrasse 34
8184 Bachenbülach
Switzerland
Phone: [phone]
Fax: [phone]
E-mail: [e-mail]
Homepage: www.anfim.it

[@the_cyd]

Hi, I'd like to clarify something (if anyone is still keeping an eye on this guide). When reassembling the doser I ran into an issue: upon putting the washer on and screwing on the nut all the way (as instructed @ 2:20-2:26) the mechanism wouldn't turn, likely because it's too tight... even with the entirety of the gear soaked in grease. Loosening up results in the spring clamp holding the nut in place instead of a proper turn. Removing the washer did allow the assembly to function properly, but it causes the lever to wobble. Any tips? Edit: using lithium-based grease instead of graphite produced better results, albeit a bit stiff still.

[@anfim]

Hey there, hmm without looking it we would suggest getting a local engineer to look at it. If not then step back through the video and see if you’ve missed a step…

[@the_cyd]

@@anfim will do, given I'm out of other options. Thanks for the reply!