Angle grinder 115mm to 125mm MOD (Parkside PWS 115)

[@jfp976]

Why don't you buy a 125mm grinder from start ? The tiny bearing and the little torque of the motor are not designed to withdraw the efforts implied by a big disk.

[@Mikkonen_DIY]

Thanks for Your comment. I also have other 125mm grinder, in this video I wanted to show the idea 🙂

[@chuyiii6934]

Fuuuui good job jeje 😅 😜

[@jfp976]

Dangerous handling of your cover at 5:55. If the cover snaps from your hands, the skin of your fingers will be seriously injured.

[@jfp976]

Last comment with no hate at all. Try and avoid buying cheap tools and specially cheap disks when you have very fast moving éléments so close to your face and hands. Gloves and face screen and cap are mandatory, not for the little sparks protection but when your disk rips off, and little debris are flying all over you. You may also overspeed à big disk putting it on a little machine where the lack of torque is compensated by a higher rpm. Check the specs of your disk before use. Have fun being safe !

[@garthqueen]

5" discs are same speed rating as 4.5" discs.Its only when you get up to 7" and above that rating drops to 6500 rpm.

[@ИгорьИванов-о1л]

...похоже, если у этого ,,чудо мастера" есть ЛОМ, но нет ШИЛА... То он не пойдёт покупать ШИЛО...))) Он выточет его из ЛОМА !!!...(((

[@bonshairstyle]

👍

[@VggGgg-o9i]

Hej

[@bonshairstyle]

🙂

[@ИгорьИванов-о1л]

...ждём видео, как сделать ,,ИЗ КУВАЛДЫ... МОЛОТОЧЕК ювелира"...))) ,,ИЗ ЛОМА...ИГЛУ"...))) ,,ИЗ КОВША ДЛЯ ГРЕЙДЕРА... ЛОПАТУ"...))) (сарказм.)

[@denisesmith4908]

Wow, Damaging the warranty on the machine! I would have returned on the grounds that not all parts fit!!!!