ANSYS ACP Tutorial Composite Bending Test Simulation

[@bayasistan]

Congratulations for your analysis, you explained it very well. However, when solved for Static Structural, "A value higher than 1 needs to be provided for maximum number of splits for contact splitting in distributed solution" ANSYS gives this error and does not provide a solution. Can you give me information about this?

[@afiqdanial3824]

What is your load here? Is there any ways to configure for different kind of loads?

[@FaradisonPurba]

in this video my load is the displacement that applied from cylinder into beam, but if you want to find force applied into beam you can input force reaction and put remote displacement into boundary condition for force reaction

[@afiqdanial3824]

@@FaradisonPurba Thank you, I will try it later on.

[@pranaychalke74]

@@FaradisonPurba which remote displacement is to be selected? because there are 3 remote displacements namely Remote displacement for load, remote displacement 2 for left support and remote displacement 3 for right support, which should be selected to get the load on the beam? please help

[@suneshnarayanan5961]

Dear brother In ACP while updating the solid model i am facing an error, Shell topology: no components found, What to do brother

[@mehmetfatihkaya4812]

Did you find any solution?

[@ArccRs]

appreciate the video, but you go through it way too fast without explaining in detail

[@Top10-k3p2s]

A waste of time