ANSYS ICEM, Fluent and Fensap-Ice Tutorial (Part 1 - Mesh Creation)

[@airfoilcfdicing7024]

Hi! Thanks for all the feedback! Sadly, I am no longer using this software, and therefore I am not so used to it and able to answer much of the questions at the moment… I would suggest consulting the ANSYS manual for any questions that might arise!

[@saadarslan4499]

hello sir, i did the same but it is showing error Warning: the mesh contain negative elements; maybe the quality of the ANSYS Fluent mesh is too worse to use what should I do?? please

[@airfoilcfdicing7024]

Hello, I think if you follow the procedure it should be fine. Check if you are using the same software version as I am in the video.

[@aparchitransh9848]

how we show the power loss due to icing effect on wind turbine blade generation

[@airfoilcfdicing7024]

Hello, do a BEM simulation of a wind turbine for two cases: First with Cl and Cd of the clean airfoil, and then with Cl and Cd of iced airfoil

[@aparchitransh9848]

@@airfoilcfdicing7024 it hppen in ansys fensap or not

[@airfoilcfdicing7024]

@@aparchitransh9848 not that I know of. It must be done separately, but it's not very difficult. It can be done in an excel file.

[@aparchitransh9848]

@@airfoilcfdicing7024 any vedio and research paper regarding this please suggest

[@airfoilcfdicing7024]

@@aparchitransh9848 These 2 videos: kzbin.info/www/bejne/pWeldKGeqseVn7M&ab_channel=EngineeringwithRosie kzbin.info/www/bejne/fWTTapadr9qkaac

[@fikair9973]

Can I get the software?

[@alone4633]

Name of software