Arctic Cat CV Boot Replacement (Old Style)

[@jackalgolfer3382]

Best video on Cv joints and boots. Clear speaking, great lighting, and not a bunch of extra talking!! Great job!!!!

[@izom]

7:35 the clamps you put on like much better then the one u take off...all boots should come with these !

[@daveordos5868]

Thank you, Gives you the info needed to do the job!!

[@ryanmassengale5652]

Good video, it helped me for sure. But why couldn't you just take off one side and slide both boots off? Guessing making sure properly greased?

[@edbonnell5141]

Outboard CV joint removal...a few taps and yours popped right off. Mine won't budge, it looks just like yours. I went from light taps to hard smacks...won't even try to budge.

[@ryanmassengale5652]

It's a pain. Hit from one side and switch to the other is what I did. After 5 minutes it finally popped off. There's a little ring inside holding it in place.

[@edbonnell5141]

@@ryanmassengale5652 I spun it around and beat on it with and without a ling brass dowel. I didn't see the point of trying penetrating oil considering it is packed with grease. In the end I removed the other end.

[@YourLocalHandyman]

I followed your instructions to replace a CV Boot on the passenger side front of my 2012 Arctic Cat 700 Mud Pro H1. I got that done, but when I went to test it, my ATV now has a clunk in it towards the back when I shift from Reverse to H or L. There's two things I did that might or might not play a part. While I had it jacked up I shifted it out of 4X4 so I could rotate the axle hub. The second thing was I rolled the bike ahead while it was in N and on the floor jack. Any ideas appreciated. Thx.

[@seanfraser8442]

Good vid! Thanks!!

[@luciocarranza193]

Thank you

[@wildtrophyhunts300]

Thanks for great video!

[@outdoorguy845]

Very good information. But I would not hit the bearing with a mallet. I would put a deep well socket or a pipe over the threaded shaft and punch the bearing in

[@christhefistful]

Thanks very good video.

[@federicogambini8922]

hello, for an arctic cat wildcat 1000 year 2015 is it the same? thanks

[@Mr.Chronic]

hey im getting volt on my 06 arctic cat dash have you ever had this

[@nathanielklemp7756]

How do I remove the front axles from the diff on a 1998 artic cat 454 4x4..

[@gregh2632]

This is how to remove a rear axel. Check out the other videos, I’m sure the front is the same. kzbin.info/www/bejne/iHSyeKSjYrNmmq8

[@patrickedwards4239]

I forgot to say there is nothing in the service manual about how to replace

[@rugby3874]

Thanks

[@patrickedwards4239]

I have to replace the boot on the secondary drive assembly, Artic Cat part #3435-067. 2002 500 auto Atv

[@ernzthomas2676]

I have a Arctic cat h1 2007 my boots are gone and need some help I don’t have any way to fix them

[@kountryquads9475]

i have an 2003 arctic cat 250 and was wondering if i pull the cv axle out will all my motor and transmission oil come out sense it is all one unit?

[@gavinpilkington3951]

Kountry Quads if u tilt the side that u remove the axle from slightly higher then the other it will not drain out

[@throwdownhard1]

Need to actually show a replacement of a NEW cv boot!