Arduino IoT Cloud and ESP8266 with DHT11 for Temperature and Humidity Monitoring, Arduino Cloud

[@exotic.unofficialnt]

Around 1:30 to 2:05 there was not much difference for the displayed temperature, was it cause of the sensor?

[@alkatechnology]

great job bro.. thanks..

[@engineersupervisor4462]

Very good project

[@why.k5max]

I've followed all the methods in the video but the results on the Hannya serial monitor sometimes even error showing the result -15 even though I checked the normal upload for dht 11 on the display The monitor shows good results 31°C But when I try to upload it for iot arduino the result is "nan" ?

[@electronic7979]

Nice

[@opusfarm7623]

What is the purpose of the 10K Ohm?

[@Duck-jc9ox]

Thanks for such a clear, artculate, informative video. What is the setup is required for the ESP card before libking it to Arduino IOT? Im assuming it must be connected to arduino uno. But does this connection include setting it up as either AT or STA in AT setup, for example? Or does Arduino IOT do this?

[@chainleang5313]

Everything works fine except the DHT11 data is not correct(sometimes nan). I have tested the DHT11 in example code and both temperature and humidity displays are almost correct.

[@aravgupta4809]

have u found the solution if yes then please share it would be relly helpful

[@adambeedle]

Great 👍

[@el_troesma]

Hola si pruebo el sensor sobre el id anda bien (clásico sin wifi) , si lo hago en el cloud la humedad me da el doble de valor. Que puede ser?

[@creativeelectronicchannel7647]

Nice idea bro

[@PSISVarshiniKN]

Sir can I get a report for this project

[@ElectroniClinic]

article link is in the description.

[@PSISVarshiniKN]

@@ElectroniClinic sir I need literature survey and methodology but it is not present in that article