Arduino LoRa RC Controller for RC Planes, RC Cars, RC Trucks, RC boat, RC Helicopter

Рет қаралды 14,328

Electronic Clinic

Күн бұрын

Пікірлер: 28

@nektarioskourakis8331 9 ай бұрын

GREAT JOB!! THE NEXT STEP IS TO ADD SENSORS ON RC HELICOPTER AND COMPLETE AND FULL LORA SERIES...THANKS IN ADVANCE!

@foebelboo 7 ай бұрын

thank you so muchhh! im making an rc car and this works so well!

@shubhamsawant5129 Жыл бұрын

What is delay in ms?

@engineer2you 4 ай бұрын

I use Lora for remote control, it delays about 1sec, so i think it is not suitable for remote control. It is so lagggg

@senseisecurityschool9337 Жыл бұрын

Is there any advantage to this implementation vs the standard ELRS that most people use? ELRS is LORA, on an Arduino-compatiblr ESP32 board. The same thing but FAR more advanced. It looks like this implementation is like ELRS, except slower, heavier, more expensive, and less reliable? Any reason to re-invent ELRS, but worse?

@PhG1961 Жыл бұрын

Great content indeed! Inspiring and entertaining!

@БогданЖивотов-щ8о 7 ай бұрын

Good afternoon, I ask for your help. According to your example, I tried to pass 4 values, and not 2 as in your example. But I encountered a problem in the receiver.

@raishamizan8905 11 ай бұрын

i have a question, if i follow the circuit diagram, the reset button does not connect to anything. will this still work ?

@GuruImperium 7 ай бұрын

Just beautiful. I would like to be able to reach out to you for some projects

@ElectroniClinic 7 ай бұрын

Sure.

@raymondmichael4987 Жыл бұрын

Going in the right direction, Towards lora mesh network

@zahidhamood6079 Жыл бұрын

Great content sir...🎉 sir plz make 8 channel tx rx...with lora..

@ElectroniClinic Жыл бұрын

Ok sure I will, I will cover this in flight controller designing.

@nuwankeerthisinghe112 6 ай бұрын

Hey, could you create a walkie-talkie using this Lora module?

@Ekirnet-one Ай бұрын

Hi I implemented the code on a card with Lora but every time I activate the motors with a l298 bridge the arduino nano freezes and I have to restart with the rst button on the arduino why does this happen

@ElectroniClinic Ай бұрын

@@Ekirnet-one check your power supply and also use a watchdog timer.

@Ekirnet-one Ай бұрын

@@ElectroniClinic Ok thanks for the answer, that was the first thing I did, I checked the input voltage to the Arduino, it is 8vdc y puse un watchdog pero a un así se queda congelado esto ocurre cuando hago avance o retroceso

@Ekirnet-one Ай бұрын

@@ElectroniClinic It was the first thing I checked, the voltage is 8 vcd, it is connected to Vin and the LorAx is connected to the 3.3 vcd of the arduino, and it even has a 470micro capacitor in Vin and I put a watchdog, it follows the problemI have already changed the Arduino nano to rule out a hardware failure, it still only happens when I move forward and backward, that's when the Arduino freezes. Could it be something else?