Killer freakin romp Brother Ed!🤟Totally controlled wild backies for days! If you can smoke a stogie and bash at the same time, you're a legend!😜🤣🤣You must have had a diff built on a Wednesday!🤣 Mine held up for a couple hard runs but it was ring that went due to no outer shim.😝under inspection, my planetary gears are getting bad wear. I'm waiting on a full rebuild kit for my rear. Going to try the extra internal shims and go from there. Great vid bro and take it easy!😎🍻
@bicketybamRC4 жыл бұрын
Thanks, Eric! Finney enough don't have an outer shim on my rear either. I'm not sure I could fit one in. There is no okay at all. I hear you on the internal gear wear. Mine are showering signs. I have a few tiny chips here and there, but it's still running!
@wyattzain54863 жыл бұрын
I guess it is kinda randomly asking but does anybody know of a good site to stream new tv shows online?
@marceloterrance35323 жыл бұрын
@Wyatt Zain flixportal :P
@wyattzain54863 жыл бұрын
@Marcelo Terrance thank you, signed up and it seems like a nice service :) I really appreciate it !!
@marceloterrance35323 жыл бұрын
@Wyatt Zain you are welcome :D
@basher-854 жыл бұрын
Nice one again! Cool to see someone not complaining about the rear diff. Mine broke after 3 runs but I replaced it with an LSD and it still drives good to me.
@trentgalloway4 жыл бұрын
Same here. Damn that powerplant is bitchen!!
@NOTORIOUS_J_RC4 жыл бұрын
Another great day of super sends Ed. Loved that touch the two trees jump. Area still needs the Noto J Landscaping touch😁. Hope I can get to it sooner than later brother.💪💪👍👊🤙
@CommanderAstigRC4 жыл бұрын
Great bash as always man. You got that EXB setup just right. Power for days. You got her spinning like a piñata LOL. Great air control and landings. Rear diff holding great.
@lridebashitrc94224 жыл бұрын
Awesome rip brother 💪👍👊🏻😱. That EXB was getting some wicked air 🚀🚀. Yeah still build my ExB family life has slowed me down. Bash on 😎😎
@prostreetcamaro4 жыл бұрын
My rear diff went on the first run. I even pulled it apart before running it. 3 shims on both sides. Pulled out the calipers and they were sized right on spec. Put it back together and topped it off properly with 30K. It was nearly empty btw. Barely a dribble under the bottom pin. With in a minute of run time lost power to the rear. Pulled it apart to find the teeth on the sun gears all very slightly rounded off. Like they were barely making contact to begin with. All parts on back order for at least a few weeks horizon is telling me. While I wait for those parts I grabbed everything needed to switch to V4 diff. I will disassemble, aluminum case, shim accordingly and likely never put the exb diff back in it. I will hold it as a spare.
@dougk40714 жыл бұрын
Exactly the same problem. Called yesterday and was told they expect the warranty replacement diffs next week. My question is do I need to inspect the center and front?
@meversesmerc17934 жыл бұрын
I love you videos, keep up the good work!
@3SonsRC4 жыл бұрын
Do you double much? Nice brother, perfect control hit after hit, always love the dialog and your bashing brother Rock on and 🤞 that rear diff stays true 🎯
@danieldelrie43874 жыл бұрын
Nice driving .I agree with you about the truck needs open diffs for steering and handling.
@dynasty48514 жыл бұрын
I love the new diffs! It works great in my outcast.
@outcastblxnut10364 жыл бұрын
Way to send that thing ed👍🏻👍🏻
@Megasty154 жыл бұрын
7 runs, my rear diff lasted 7 minutes. Luck of the draw, much. The LSD in the rear is bulletproof, but it drives like it's in tornado alley.
@bicketybamRC4 жыл бұрын
And on the 7th run, God touched my diff and made it bulletproof!
@Scolecite4 жыл бұрын
@@bicketybamRC Hey Bam, I'm from CT near the BMX track. I just picked up an Outcast 8s! If you would like to bash together sometime, please let me know! I am loving this truck.
@pat_ranch40644 жыл бұрын
Tree trimming in style again 👍
@bicketybamRC4 жыл бұрын
Best way to prune them!
@FreshlyFried4 жыл бұрын
Your lucky for sure. I love my exb but 4 stock diffs have blown. I had to put a front diff in.
@yonicozac4 жыл бұрын
Sublime jumping! a joy to see you drive. Did you consider switching around the center diff lsd plate to avoid the over steer?
@bicketybamRC4 жыл бұрын
I haven't. I'm pretty used to it because I run heavy fluid in the center of my other trucks. This one just has a ton of power 😎👊👍
@jonowillmer4 жыл бұрын
You really put the Bash into Bashing! Those high speed rotations are nuts Bro!!! I'm so jealous of your ESC motor combo! What pinion did you settle on, it looks fast enough for sure! How are the temps?
@bicketybamRC4 жыл бұрын
I'm running a 23t and without fans the motor runs hot. When the fans are working the motor is fine. If I could do it over again I would have went with a 21t. 23t is overkill 😅
@jonowillmer4 жыл бұрын
@@bicketybamRC thanks for the info it is very helpful, the car looks fantastic under your control.
@jasonbudd2950Jag4 жыл бұрын
Epic bash. R/D Still holding out. 💪 👊 If I got one, I was thinking of adding the LSD Plates to R/D 😂 I know it would be twitchy AF but power would be insane all 3 diff's with LSD. Your thoughts buddy 💭? Also can I ask are you running that CC Can in Sensored mode? TIA 🙏
@bicketybamRC4 жыл бұрын
Yes sensored and with the rear running LSD it would badly understeer
@DSC13204 жыл бұрын
So I have about 20 packs through my exb. 22t 1650kv 4092 . Granted I added 3 lsd plates to each side without the locking plates so it still open diff. I absolutely love the truck and actually prefer it to my built m2c rigs. I think because its lighter and have so much air control without the added weight. My chassis was almost solid aluminum after about 5 packs. How does yours still look barely used.
@deontay79ify4 жыл бұрын
Man I love it bro. U speaking the truth. Fucking just constantly crying. Shits annoying. My diffs been holding up and I’ve sent it higher then u and on 8s🤣. Great vids as always 👊🏽👊🏽
@petegoodbashrc15204 жыл бұрын
I Can't get a fan to work on the motor they always break on mine ,sweet jumps it looks dialed in 👌
@3SonsRC4 жыл бұрын
Try the Power Hobbies duel fan setup, I have two in my 6s rigs and have sent them over 100ft plenty of times with no issues. Even take a few light poles at 70+ ft and still fine 😱 What's nice is they come with the Y connector 👍 best value out there!
@onemansvideos21344 жыл бұрын
If I ran that power plant my throttle endpoint would be set at around 55-65% till I got used to it...I usually run most my rigs at around 75-80% throttle endpoint batteries last longer also
@Justinazrc4 жыл бұрын
Nice run Ed! I am trying to kill mine with no luck haha!
@olds97lss4 жыл бұрын
Short of driving stupid by purposefully landing on power, seems like it's holding up great. Your not being easy on the throttle when accelerating either. I was curious if you regeared to avoid overheating like the first time out, or was it just adding the better fan on the esc that kept the temps in check?
@bicketybamRC4 жыл бұрын
Fans!
@daviddobson204 жыл бұрын
Might have gotten lucky to get one that was done right.
@ZSMracing4 жыл бұрын
Yea the shimming is totally off I blew my diff in 2 days after a handful of runs and when it went out it would work for a second then make a super bad noise then work and then it just didn’t work but I had to send it to see how long it’d last😂😂😂
@ImHedgess4 жыл бұрын
How to you keep your pinion on? I got a castle creations 21t and I blue loctite it and it comes loose after 5 minutes??
@bicketybamRC4 жыл бұрын
Use red 😎
@MrGravewormy4 жыл бұрын
what in gods name are u running for diff fluids...this thing likes to flick with such power... pls setup
@bicketybamRC4 жыл бұрын
50/200/30 F/C/R
@barxkyRC4 жыл бұрын
what ramp are those? can u send a link? thanks
@bicketybamRC4 жыл бұрын
They no longer make them ☹️
@ddbrink6633 жыл бұрын
where did u get them ramps?
@bicketybamRC3 жыл бұрын
Amazon but the company that made them doesn't make them any more.
@FreshlyFried4 жыл бұрын
I have to say tho. Your not testing the diff much by landing off throttle and such.
@FreshlyFried4 жыл бұрын
And keep in mind. When you break one... they aren’t any spares yet. I had to go to a buddies shop and buy the front diff out of his display