Assembling the Tree of Lights

Watch as Jason Woodward from Christmas Designers assembles the commercial Tree of Lights. This ultra-compact design comes together in as little as half an hour with only a few basic hand tools, making it a quick and dazzling choice for your outdoor Christmas display.
Shop 15’ Tree of Lights:
www.christmasd...
Shop 20’ Tree of Lights:
www.christmasd...
Assembly Instructions:
1. Place the base of the tree where you want the center to be. Install each of the six legs by inserting them into the pegs of the base.
2. Place the stabilizing plate onto the base with the larger opening on the rod side. Secure the bolts with a wrench.
3. Secure arched L-brackets to the base legs, creating a circular frame. Tighten each piece with the wrench.
4. Install the center poles, starting with the short pole first. Secure the pole with the bolts and wrench. Insert the connector sleeve and continue to insert the rest of the pole and sleeve pieces, alternating between each.
5. Once you can no longer reach the top of the pole, tip it over to the side to complete the pole installation. Attach the tree top to the end of the pole.
** Note ** If a tree topper is used on the tree, do not tip the tree on its side. Instead, use lift equipment to install the tree and topper.
6. Lay the light lines in straight rows on the ground prior to installation, ensuring that they are detangled. Lines are labeled 1 to 12, and it does not matter what order you install the lines. Begin adding the light line to the attachment ring with the carabiner. Keeping the lines straight and uncrossed, clip the bottom carabiner into the bottom L-bracket.
7. After the light lines are installed, tip the tree upright by walking up the pole slowly, paying attention to the weight of the base. Consult the Installation Instruction Manual on how to properly weigh down the tree base.
8. Please note: wiring instructions have been updated from the video. Please review the following diagram for new instructions on wiring your tree together:
support.christ...
For the tree wiring, each line is labeled with a number (1 to 12) and a letter (F for Female, M for Male). Daisy-chain 6 of the lines together, making sure to plug each numbered male line into a different numbered female line. Once 6 lines (half the tree) are daisy-chained together, plug these into an extension cord. Next, daisy-chain the second half of the tree together and run a second extension cord.
Note: do not daisy-chain all 12 lines together.
9. Loosen the bolts at the base of the tree. Tighten the threaded rod to raise the tree pole and tighten the light strands. Re-tighten the bolts at the base of the tree.
10. Plug your tree in and enjoy the show!