Audi Volkswagen 2.0TFSI Fuel Injector Replacement The Easy Way !!! For Business Contact : Nathan's BMW Workshop Po Box 115 Altenburg Mo 63732 nathan.youtube@yahoo.com
Пікірлер: 96
@harveys.28218 ай бұрын
Perfect video, I’m doing this project next week I’m installing 4 new bosch injector do I need to reprogram the ecu or is it just plug and play Thank you
@texwan Жыл бұрын
Thank you for this video. The only one I've found that talks about how to remove the fuel rail from the intake manifold. That was driving me nuts!
@Unpluggeddiagandprogramming Жыл бұрын
The white ring on the injector is a Teflon seal. And you need to be careful not to get oil on it or contaminate it. Can cause the injector not to seal in the engine block.
@greatscott7553 жыл бұрын
I have one injector on cylinder one which seems to be sticking open. Should I remove the intake manifold?
@Jessica-kb4pl7 ай бұрын
i have a 2009 Passat KOmfort. the intake is basically if not exactly the same. why do the replacement seal kits come with this one extra piece? looks like a ring with 3 short ...legs. do i need this pc? or is this like an appendix? Has a purpose but not really necessary. thanks.
@RobyFTW8 ай бұрын
Audi a4 b8.5 gave me cylinder 4 misfire on obd reader. Would replacing the injectors do anything ? Stage 1 195hp with a default ecu tune
@geo39483 жыл бұрын
Hey Nathan , i was watching this video which is awesome and very helpful, but would you be able to show how you started from the beginning to take off the fuel injectors from the beginning? i have this issue and that would be very helpful if you had a video from the start , again thanks for this video :)
@Tino2o93 жыл бұрын
Intake manifold removal?
@geo39483 жыл бұрын
@@Tino2o9 yes please
@Tino2o93 жыл бұрын
@@geo3948 humble mechanic has a good one. Just look up tsi intake manifold removal. Might be slightly different depending on car but should be relatively the same.
@geo39483 жыл бұрын
@@Tino2o9 ok great thanks again 😘👍
@bbjazzmanjazzman7721 Жыл бұрын
This is sorta part 2 on this same car..
@davidbarthel9976 Жыл бұрын
Very helpful video. I have a VW cc with the same engine. It's the worst car I have ever owned unless some its problems can be corrected. I am in the process of replacing the water pump, but the car has an extreme amount of carbon. The oil is black immediately after changing it.
@eeemuse Жыл бұрын
Hi David, i'm also in the process of changing my leaky water pump. How things went for ya?
@phonkyfeel111 ай бұрын
Direct injection. Carbon clean via walnut blast or chemical. Regardless you are removing the intake. Fuel additives DO NOT REACH THE VALVES. Remove intake and blast or chemical clean those ports. Have fun!!
@gregcowart82293 жыл бұрын
Enjoy the videos dude but I am a bmw slash Chevy man, but I will still keep watching learn something new every day keep up the good work Nate
@workweb225510 ай бұрын
once the new injectors have been installed... do they have to be coded via diagnosis... or is it simply enough to change them?
@Viper38707509 ай бұрын
Hey did you ever find this out? Sucks Nathan never replied back to you. I'm needing to know this information myself. I've found that the TDI engines with the massively sized injectors need to be reprogramed to the car but I can't find any info regarding our 2.0T FSI engines.
@harveys.28218 ай бұрын
@@Viper3870750any updates?
@workweb22557 ай бұрын
@@Viper3870750 From what I understand, you just simply replace the injectors without programming anything. In a few months I will install the new injectors.
@darkomarko68575 ай бұрын
Droselklape muss neu programmiren!
@steezyg97463 жыл бұрын
That looked a lot easier than I thought it would be, now I just have to hurt the wallet and buy the injectors lol
@gregcowart82293 жыл бұрын
I hope ur right about the all vehicle ATF transmission fluid my 08 bmw e93 was a little low so I used it to top it off about 3/4 of a quart
@NathansBMWWorkshop3 жыл бұрын
I still use the valvoline max life multi vehicle for those , never had a issue
@Matthew-uf1oh3 жыл бұрын
He made the installation of the intake manifold more difficult than it had to be
@luddeluring3 жыл бұрын
I am no expert but aren’t those metal clips supposed to be put on after the injector is in place to lock them in place?
@Jhugh173 жыл бұрын
Yes
@bbjazzmanjazzman7721 Жыл бұрын
Ya he doesn't care to show important details that probably could cause failure for the unfamiliar DIY shade tree mechanic..JS..vids a bit incomplete and sus...
@johnriley215 Жыл бұрын
Thanks, Your video helped me answer some questions.
@hugomacedo2160 Жыл бұрын
Would it cause the car to run lean as well?
@Popperonii3 жыл бұрын
Would this be the same procedure for an Audi A4 Quattro 2013?
@jonnyboy7163 жыл бұрын
Yes it would
@bbjazzmanjazzman7721 Жыл бұрын
Yes same engine.. quattro=4 WD..
@cage74553 жыл бұрын
Man u made that look difficult
@phonkyfeel111 ай бұрын
😆
@Ceas20002 жыл бұрын
Where can I find that non petroleum no silicone lube?
@milehigh30542 жыл бұрын
How many miles were on that?
@chiefg71 Жыл бұрын
What were the symptoms of bad fuel injectors.. currently feel like i’m going through this with my 09 audi a4 quattro premium plus and i’m not sure 100% sure if it’s injectors or timing chain……..
@jakobbecker6435 Жыл бұрын
I had a stuck open injector and the car shut that cylinder off and it reeked of fuel. Pulled the plug and it also smelled like fuel.
@crylas3637 Жыл бұрын
Have you changed the timing chain?
@chiefg71 Жыл бұрын
@@crylas3637 i have not actually what would be symptoms of bad timing chain
@jakobbecker6435 Жыл бұрын
@@chiefg71 well it would be throwing a code that would really to a cam/crank position or correlation
@kspree96492 жыл бұрын
Do i have to adapt new injectors ? I replaced mine now im getting misfires epc light rough idle i replaced spark plugs and coils cleaned valves
@jonmayo1658 Жыл бұрын
Did you fix it
@redemptionx2918 Жыл бұрын
@@jonmayo1658 same problem
@snoopy5736 Жыл бұрын
What happened? Did u get it?
@kspree9649 Жыл бұрын
@@snoopy5736 no i cant figure it out code is 192700 open circuit not getting power to aux pump already replaced pump and fuse is good
@TheWeedOperation11 ай бұрын
You don't need to adapt the injectors. But you will need to clear all the engine codes so the ecu can learn based on the newly installed injectors. If the issues persist most likely you'll need to re-inspect your work for any mistakes in re-assembly.
@vernoncampbell811Ай бұрын
I install the injectors into the head. Much easier, fully seat them. Put a bit if silicone grease on o rings then slide the intake and furl rail down onto the injectors- much easier
@Hatchisadcat17 күн бұрын
Thanks, I'd like to see the same for Audi A5 🙏
@ranirupeiris2 жыл бұрын
Why did you replaced instead of checking and cleaning
@bbjazzmanjazzman7721 Жыл бұрын
I agree..wonder why he didn't show checking the OHMS,if they checked out good then all was needed was clean out, squeeze a bit of fuel into the injector ..use 9v battery to energize and check spray pattern on some clean cardboard.. those injectors are insanely expensive.. but
@hydrainarms31353 жыл бұрын
Can they be cleaned individually rather then bring replaced
@guybuddy Жыл бұрын
If you are going to do this, DO A CARB CLEAN WHILE YOURE IN THERE! It is not a small job to get to the fuel injectors on this motor.
@mpkohout13 жыл бұрын
How many miles are on the car? Did you say..?
@jayb78133 жыл бұрын
so no carbon cleaning done? It was so easy to get to!
@AngelRodriguez-jv6oc2 жыл бұрын
What was the problem ? Codes ? Or why u change em
@snoopy5736 Жыл бұрын
Did u not see the video?
@guybuddy Жыл бұрын
I'm more curious as to how you got everything out without separating the manifold....
@briand.riggsriggs9617 Жыл бұрын
How much would this cost to have someone do it
@theengineer6213 Жыл бұрын
whats the cost for a job like this? average/ballpark?
@bbjazzmanjazzman7721 Жыл бұрын
$1,440
@bm_wuratli688323 күн бұрын
@@bbjazzmanjazzman7721so I can do myself then let's someone code it? Isn't that better option for amateur? And money ofc😂
@nelsonmartinez12813 жыл бұрын
Do you need any coding just swap the new ones on and erase the codes?
@bbjazzmanjazzman7721 Жыл бұрын
You will need someone with a decent scan tool that can erased stored codes..
@p4duk3s3 жыл бұрын
at 10:13 why is there a smoke coming from the engine bay?
@wayneahh3 жыл бұрын
Likely oil/fuel on exhaust when removing manifold/fuel rail
@bbjazzmanjazzman7721 Жыл бұрын
Bcse he was sloppy and didn't cover that area with clean towels or rags..
@NitroVipers33 жыл бұрын
Have to down vote for ZERO video of putting the injectors back into the motor... one of the most important parts.
@lifeindetale Жыл бұрын
That's crazy you pulled out the intake manifold with the injectors in place!. Must have done a lot of prying with screwdrivers.. yikes
@gregcowart82293 жыл бұрын
What’s up Nate
@lp25653 жыл бұрын
Great Video!
@deniskucevic225717 күн бұрын
You sound exactly like Ross creations
@brahskinator5 ай бұрын
Why on earth would you do it this way? They should be inserted into the head first and never a need to disconnect the fuel rail,, those bottom seals should be dry. But hey I guess it got done with no leaks so 🤷♂️
@gregcowart82293 жыл бұрын
Thanks Nate it’s definitely cheaper
@246alfa9 ай бұрын
These injectors are easily washed, then checked and put back into the car.
@kfrdubber3 жыл бұрын
Ticking might be the dual mass flywheel
@ericjoziah50853 жыл бұрын
Sorry to be so offtopic but does anybody know of a method to log back into an Instagram account..? I stupidly forgot the account password. I would appreciate any assistance you can give me.
@hamzajaxx22303 жыл бұрын
@Eric Joziah instablaster =)
@TheWeedOperation11 ай бұрын
Actually not necessarily. Those direct injected engines make alot of noise thanks to the fuel injectors. The engine cover and hood has sound proofed to muffle those sounds from being heard in the cabin. Just needs to reinstall the engine cover and close the hood.
@adamkhan87612 жыл бұрын
Thank you so much
@Jhugh173 жыл бұрын
The bottom one is washer seal
@venicesaint15003 жыл бұрын
Nice video even tho I have a 3.2
@tech42long353 жыл бұрын
Nice Video, fun to watch.. Man.. lowered.. and chinese dark tail-lights.. i feel bad for that car. handles like crap, looks walmart. The factory engineers and design team DEF knows better than youngsters. And ya.. the girls dont know and dont care anyway about lowering, and blak-outs. haha.. whtvr.
@jessesward94293 жыл бұрын
There’s a snake in my boot
@bombing6263 жыл бұрын
A hard whaaaaat?
@130bowman3 жыл бұрын
Cam chain death rattle
@nelsonmartinez12812 жыл бұрын
Nop is the high pressure fuel pump
@larsk77084 ай бұрын
Shows nothing how to remove from car. What I crap video..