Aufero Laser 2 - Ortur - Setup and Testing - Is it any good?

[@blameitontherain29]

Really enjoyed your video- very well done :)

[@jonasveryser696]

Hey, i have limit switches from a 3d printer would it be posibel to ad those? On the machine

[@MiddleRoomWorkshop]

Hello Jonas Veryser, thank you for your comment. I am not sure about that. I notice that the mainboard has several free connectors, perhaps the two-pin connectors could be used for that, but I am not sure as I couldn't find any additional supporting document about the board itself. I will definitely investigate further, and return you feedback once I am able to give you the right answer. I hope it helps. Ciao

[@peterbooth3624]

Is it possible to upgrade to the Ortur 10 watt head on the Aufero 2 ?

[@MiddleRoomWorkshop]

Hi, Peter booth; thank you for your comment. Yes, you can do that, but you need to select one specifically for Aufero when you buy it. See here, for example, s.click.aliexpress.com/e/_DECMcn5 Ciao and Happy New Year

[@weilam03]

Very good explanation.

[@livelandings747]

Does this cut 250gsm card.

[@MiddleRoomWorkshop]

Hi Bruce Suttie, thank you for your comment. That will be like butter for the machine. I haven't tried that specific thickness, but I cut 400gsm at 50% power and 1200mm/min speed. The laser in this machine can handle 3mm plywood in a single pass. You may find difficulties, however, if you want to cut something below 100gsm as the paper is too thin and it is hard to get it in focus. Ciao

[@livelandings747]

@@MiddleRoomWorkshop thank you