AUMA Actuators - EWG Feedback

[@bw26brw86]

Good day how do I setup the 4 - 20mA feedback to scada

[@saithishsaje9653]

I need solutions for open and close feedback

[@perdesh1990]

If you find tell me also

[@seagle85]

I need help understanding how to wire my valve

[@shamsulhoda1897]

How to inject the 4-20mA in Auma Actuator

[@dyto1715]

My auma was good. I tried to do this way .but now stopped at 5.7 mA when i send zero from scada.but open and close local are working fine.i use 3_4 wire but .wiring only at 23 .24 could you tell me .how can i solve this

[@AUMAActuators-USA]

Hi DyTo, can you please provide me your location so I may connect you with a local service representative?

[@kysuci4105]

thanks.

[@faisalmalik7408]

exilent

[@asirasperislamicruleswitho3022]

AUMAN MANUFACTURER ENGINEER ELECTRIC CIRCUIT DESIGNER IS NOT GOOD , I Received The valves we Done Heavy Mistake during Calibration due to bad engineering , I Auma NEED i can Highlight these issue with your Engineer.

[@AUMAActuators-USA]

Hi Asir, can you please provide me your location so I may connect you with a local service representative?