AutoCAD 3D, bolt and nut drawing, autoCAD training

ES: in this video show how to draw bolt and nut buy use command c, command pol, command ext, command cha, command in, command helix, command su, command ...
for more videos please go to my channel thank YOU.

[@pramodmyakal6875]

please add your voice also somethimes things are not understood

[@KiranWarke]

please add voice to video so we understand the commands operated.

[@Eangsopheann]

yes, i will

[@s.j.graphicsdesignaccounti5340]

i love it you are the best designer

[@bpetnoi1472]

I believe you did much more work than necessary. I would have made a copy of the bolt and placed it on the nut. I would then use subtract to remove the bolt from the nut leaving threads on the nut. Much easier than making the threads on the nut.

[@douglasvieira1824]

Thanks. Good job!!👏🏼👏🏼👏🏼👏🏼👏🏼👏🏼

[@Eangsopheann]

thank you

[@zeezoo6174]

nice viedo :) keep up the good work

[@mghvinjilia]

Sir! Why do you use a triangle two times, one on the bottom and another on the top of the helix to sweep. It would be enough one time?!

[@Eangsopheann]

because of the top one for make thread and buttom to make thread end smooth and look nice.

[@halimkhan8789]

wonderful

[@s.j.graphicsdesignaccounti5340]

please sir ji make a drone, table fan, celling fan, sofa, table, chair

[@IvanJest]

when using the sweep command, the triangle turned out to be only at the bottom, but not at the top, why?

[@Eangsopheann]

i am not clear about you question please again, Thank you

[@ankitrai2266]

Add voice bhai sahab

[@weishitang4683]

对我有启发！好。

[@umarrider3332]

If we draw a window in 3d in a specific dimension. But in our project windows dimension not same. Can we insert Windows without making a new window with new dimension.

[@Lussacregan]

If you can't say a word, it's not a tutorial, I think you reposted someone's video, editing just clicks 👎

[@Eangsopheann]

yes, i had new share video have sound, thank you.