Nut and Bolt Design in Autocad

[@duwatv7901]

Very straight forward, thank you somuch!

[@Abhihh4657]

The Best Vedio I ever Found To Understand ❤

[@musicaselecta715]

VERY GOOD

[@MrJohnnykhoo88]

Thank you Sir, is really helpful.

[@malindasilva4898]

Dear brother, While thanking you for the explanation I would like to point out about a small technical error. When creating the bolt, the helix should union with it and should not subtract. Otherwise the bolt will pass through the nut without any revolve.

[@ashoksapkota53]

Cool

[@techiebud1829]

Thanks bro😍

[@knvkrishna5432]

Really helpful. Thank you very much for such Bro......

[@keithcanonroma5328]

thank you so much sir!!!!!!!!! YOU'RE THE BEST! SHEEEEEEESH

[@javencera]

Really helpful. Thank you very much for such content.

[@waspmklen4850]

Thanks so much.I'm a beginner,and I see it very good

[@bpanthi977]

Thanks for uploading such content. It was really helpful. Keep going! Amazing video. 🔥

[@techiebud1829]

You are welcome mitra😍and thanks for encouraging words🤗🤣

[@FarhadAli-im9mz]

Great Sir

[@bharatdkl19]

Hello Frands😂😂 Ramro xa hai video. Keep it up...

[@techiebud1829]

I'm thankful for your words frands🤗🤣

[@aparnashinygottem3120]

Thank you so much sir its helpful

[@santhoshkumar-il8rs]

Useful

[@Madbootdestruction]

Very nice but instead of the circle being the profile of your sweep, can you do this with a triangle for a more realistic looking thread?

[@egwimcollins6015]

Great

[@rameshverrajput1582]

👌👌👌👌🙏🏻🙏🏻🙏🏻🙏🏻

[@NamelessKupal]

Everything is fine but when I was doing the helix at 6:22 minutes, instead of going down, the helix goes up after I type 30, what should I do?

[@umashankaryadav5439]

Use - if thread going wrong side or use cursor for up or down

[@girlforsaken1522]

Now how you convert it to pdf with the point of views?

[@umashankaryadav5439]

Use plot

[@sureshv1464]

Nicr

[@schoolofpassion]

Thanks

[@kritarthtripathi7157]

Sir unable to sweep bol rha hai