Automatic Clothes Drying Stand using Arduino, Servo, Raindrop Sensor I Robo Army I Arduino Project

[@kaylienadineobligado4984]

Sir another question 2200 mAh did you use in battery?

[@robo_army_]

Yes

[@refalst2370]

Hi,where did you get the battery holder?

[@robo_army_]

Hi! Thank you for your interest. The battery holder and all the other components needed to create projects like this are available in our RoboKits. We've launched these kits to make it easy for you to build various exciting projects. Each kit includes all the essential materials, step-by-step guides, and even live classes to help you get started. Check them out to explore more!: www.amazon.in/dp/B0DHPP5HK7 😊

[@saprarajubhai321]

Thank you sir 🎉❤🎉😊😊🎉

[@robo_army_]

Most welcome 😊. Stay connected for more such interesting project knowledge.

[@HushXYZ]

Sir upload more videoa like this🙏💛

[@robo_army_]

Sure 👍

[@refalst2370]

The arduino is getting hotter whats the issue? the battery is 5000mAh is it the problem?

[@robo_army_]

The issue is likely the voltage, not the battery capacity (mAh). Check if the battery voltage exceeds the Arduino's input range (e.g., 7-12V for UNO via VIN). Using a higher voltage can cause overheating. Use a compatible power source.

[@refalst2370]

@@robo_army_ but the battery that i got is 3.7v

[@refalst2370]

3.7 v for each battery so i had 2 of them

[@robo_army_]

Hi! If you're using two 3.7V batteries in series (7.4V total), ensure you're powering the Arduino through the VIN pin or power port. Also, double-check all connections for shorts or incorrect wiring. 😊

[@kaylienadineobligado4984]

The servo motor didn't work... need reply asap😭

[@robo_army_]

Hi! Thanks for watching the video and sharing your feedback. If your servo motor isn't working, here are a few things you can check: 1️⃣ Power Supply: Ensure your servo motor is getting sufficient power. Some servos require an external power source, especially if the Arduino can't supply enough current. 2️⃣ Connections: Double-check all connections (VCC, GND, and Signal) to make sure they're secure and correct. 3️⃣ Code: Verify the code uploaded to your Arduino. Make sure the servo library is included, and the signal pin in the code matches the pin you're using. 4️⃣ Rain Sensor: Ensure the rain sensor is working and triggering correctly; this might affect the servo logic. If you need further help, feel free to share more details about your setup, and I’ll do my best to assist! 😊

[@kaylienadineobligado4984]

@@robo_army_ thank you

[@kaylienadineobligado4984]

@@robo_army_ another question what mAh battery did you use?

[@robo_army_]

2200 mAh