Thank you for this video. This helped a lot with my 5 speed conversion. One thing worth noting, I have an AU delivered Spec R and the S14 front half of the tail shaft bolted straight up without issue.
@Piperfan713 жыл бұрын
Great job Captain. Always calm and focused 👍and no bad words during this hard work 😜
@Tunasub1993 Жыл бұрын
What a fantastic video! May i ask, where did you get your S15?
@rm63302 жыл бұрын
Did I miss the bit where you drilled out the firewall to fit the clutch master cylinder?
@1viva3 жыл бұрын
Amazing video Sam. Love the step by step explanations & shots...and all the detailed infos about all the parts needed. Just to think that you are a self learnt Mechanic!... Very impressive. Congratulations.👍👍
@putin34232 жыл бұрын
Toucan Sam big nose is a failed mechanic.
@joshtoth-thomas58472 жыл бұрын
Good Vid! Are there no other sensors that need wiring up (neutral position, 5th gear)? Did you not replace the ECU with one from a manual to prevent a CEL?
@rensmekes41542 жыл бұрын
Hi Sam. I have a question about the manual conversion. I want to swap my JDM Silvia S14a Q's SR20DE from auto to manual. *Do I have to remove the gearbox ECU also? *How about the TPS? *Do you have problems with "high revs" or "NVCS" because I read about it? Someone asked the following question on a topic; "Will you also change the ECU? With mine I had a problem with it holding high revs after coming to a stop (normal behaviour for an auto) and it was driving me nuts - the quick way around it was to short circuit auto transmission circuitry so it thinks it is in neutral - but then you lose the NVCS" Please let me know Cheers, Rens
@jeffreylafortune26773 жыл бұрын
Very nice video! Love the tips and tricks👌🏼
@putin34232 жыл бұрын
Dumb video recorded with a potato. Toucan Sam did this whole video and hope it was good but its trashed HAHA 200 views. failed!
@ryank6160 Жыл бұрын
How hard would it be to convert a manual to an auto/cost of doing so?
@funkad953 жыл бұрын
Hey Sam. Have you noticed an increase in NVH with that clutch setup? I get some bad vibrations on deceleration, around 2.5k rpm with my SR20 and Z33 clutch setup. I've read online that the friction disk springs can resonate if not matched correctly to the application. I have a manual swapped s14.
@outsidesamm3 жыл бұрын
Nothing for me
@putin34232 жыл бұрын
Don't ask advise from this dude. He's a fail mechanic and failed youtuber
@playz98472 жыл бұрын
How much did you buy the car for? And Is this USA?
@aladinlaki87592 жыл бұрын
How much did all of this cost?
@db_outlaw82783 жыл бұрын
Did they make the Spec R Auto??? I thought it was manual only
@outsidesamm3 жыл бұрын
They came in auto!
@kitsze10882 жыл бұрын
Do you need to replace the starting motor to a manual one?