Bad Check valve Diagnosis and follow up

In this episode THE Guru trouble shoots a compressor and instructs the customer how to change the check valve himself.
thecompressorguru.com
The Rendezvous 847 Drane Highway Osceola Mills Pa 16666
242 Ingersoll rand, Check valve, Compressor won’t start under load, ¾ check valve, compressor repair, compressor rebuild, compressor overhaul, compressor service,

[@paulsthormes251]

Thanks for sharing 👍

[@johnnelwhite]

I just picked up an older speedair unit and I think this may be the reason why they sold it to me for so cheap. I'll be picking up a new check valve

[@THECompressorGuru]

check out the check valve page on thecompressorguru.com and contact me and we can get 1 coming your way. Bud

[@kevinmichael9363]

Good job!

[@THECompressorGuru]

Is this the kevin I have know since the 70s?

[@kevinmichael9363]

@@THECompressorGuru yes!

[@Whitewateradventure970]

Nice hat

[@THECompressorGuru]

you have to look long and hard around here to find a hat for the other side:)

[@Whitewateradventure970]

@@THECompressorGuru yes sir

[@tigwelding123]

👍💪💯

[@stevecha3612]

So I have an older IR T30 253 pump and it doesn’t have a port from the check valve, instead there is a port from the 2nd stage output that feeds into the center faceplate of the pump. The pressure switch has one air line connection directly into the tank. Should I reconfigure my pump airlines for better start-up? You mentioned that IR used to do it one way for a short while and then changed it, wondering if I have that configuration. Thanks!

[@THECompressorGuru]

The short answer is do not change anything till you have a starting problem. the set up you currently have works the same as the check valve and pressure switch. when to switch it is when the unloader in the "faceplate" stops unloading. thus hard starting. there are several scenarios to this . so feel free to contact me through thecompressorguru.com Bud

[@cyclesportservices3323]

Hello question my air compressor, will start and while building up pressure and it reaches 40 to 50 psi the electric motor start kinda slowing down and speeding up then it slows down and then trips the breaker, any help in the right direction will be highly appreciated

[@THECompressorGuru]

I doubt that the motor is actually changing speeds. I am guessing what you are hearing is the pump after the belt is slipping some and catching back up. normally I would tell you tighten the belt and see how it runs . but since you are kicking the breaker I think you probably have some sort of issue with the pump . I could use more info on what machine this is, specifically is it a 2 stage pump?. you can reply here or contact me through thecompressorguru.com I am about to walk out of the office for the day. I am on the road for much of the next 2 days. Bud