Badland Buggy ST2 Walk around GSXR600 Mini Buggy

[@johnsmithfakename8422]

I like the badland buggy design, nice work, very clean.

[@drydenmatt]

JohnSmith FakeName thanks man!

[@mohamadskandar8247]

Noise 👍👍👍

[@keatisakdaroj9415]

สวยมาก ชอบๆ

[@witosarlaw]

Mantap bang.. saya juga lagi bikin mini buggy..👍🙏😊

[@КаренАракелян-и4й]

Wou!

[@kmuralikrishna1582]

Really Appreciate it, where can we get the frame/chassis measurements plan ? Hope you will reply.

[@radbuggies976]

The basic frame is a badland buggy st2, you can order plans from them.

[@modsar1]

39k views!! Holy cow.

[@randycarroll7566]

Did u build the frame ?

[@זהרהולנד]

nice work!!! whic model of rack and pinion did you use?

[@tobiaspimentacartcross6520]

Top d ++++jow

[@Wildkat9797]

Just got my rolling frame mocked up, looks like I will have to stretch mine to fit my sv1000 in, went from an edge design to this because of the simplicity. How do you have the rear drivetrain setup? I was going to go to a 930 cv but it seems too big going to the rear knuckles and bearings for what I have, dont know what the plans called for.

[@drydenmatt]

Plans called for u-joints that could handle 10hp. These are axles from a pontiac solstice (what i had laying around at the time). The center section is all custom, made from splined shaft and some hubs from Grob spline. The axles i cut down and made new splined female end on inner welded to the joint.

[@mohamadskandar8247]

Hi lik

[@Ratkill9000]

So what CV axles, and wheel hubs did you use on this? Been contemplating buying this or the ST2NG and Badlands states using some version of Ujoints.

[@radbuggies976]

i made my own system using pontiac solstice axles and hubs

[@radbuggies976]

mostly because they were what was available at the time. i used a splined shaft from Grob with their hubs for the center section between the inner cvs

[@Ratkill9000]

I have VW bug CV axles for the old school bug. They seem to be almost too short for something like this, unless I make them longer. How wide are the Solstice axles? What I have are only 16 3/4" or so end to end.

[@ЛолКек-ж7и]

why you dont test this baggy ?

[@radbuggies976]

I did test it, and disassembled it before powder coating. This video was right after putting it all back together, the cleanest it will ever be!