Installing a Badlands ZXR 3500 winch on my Rancher. Took a lot longer for the installation but sure glad I did it!
Пікірлер: 29
@joeysane4163 ай бұрын
Great video! I didn't know about the accessory harnesses but thats the route im going, thank you
@jerrysharp79612 жыл бұрын
Best video out there on how to install a winch thanks
@riethridge4662 жыл бұрын
That’s great to hear and I’m glad it helped you out. Thank you for reaching out and for watching my video.
@MrLeoprovodnik2 жыл бұрын
Great video. Great instructions!
@riethridge4662 жыл бұрын
Thank you!
@doncomptonjr9324 Жыл бұрын
Excellent info professional introduction
@riethridge466 Жыл бұрын
Thank you!
@Andrew_Walters1381 Жыл бұрын
I just did this, pain in the ass, which is mostly harbor freights fault with the short wires to the solenoid. I don’t really like where mine is mounted but hopefully it will last for a couple years. Added fluid film on the connects to keep it from corroding.
@yallacrazy3760 Жыл бұрын
Thank you.
@jmadar51 Жыл бұрын
Need more light 💡 after installation
@caseysticco13582 жыл бұрын
Can you list the kfi mount that you used for the rancher
@riethridge4662 жыл бұрын
Here you go. Kfi 10-2175 Winch Mount Hon... www.amazon.com/dp/B07RG6L3MR?ref=ppx_pop_mob_ap_share
@northamptonartscouncil2 жыл бұрын
I took a look at the KFI website. How did you choose the winch Mount bracket? KFI site doesn't list badlands winches. I'm trying to install a Badlands 2500 on my '12 Honda Rancher TRX420FM.
@99mroutdoorsman2 жыл бұрын
Why did you use the extra harness
@riethridge4662 жыл бұрын
I didn’t want to spice the factory wires. I figure that if I messed something up, all I would have to do is to disconnect the harness and no harm was done to the ATV.
@jrdz21202 жыл бұрын
Why is the label on the winch upside down?
@riethridge4662 жыл бұрын
That’s a great question! I was wondering the same thing.
@halyoung94892 жыл бұрын
Mine is mounted the same. No big deal
@jmadar51 Жыл бұрын
You need more light so we can see every step
@jmadar51 Жыл бұрын
You needed to show where each part of the wench bracket bolts to the bumper assembly
@jmadar51 Жыл бұрын
No lighting under wheeler would have been nice
@johnhummel4737 Жыл бұрын
Would not recommend a Badland 2500 . None of the holes lined up and the instructions even tell you that you have to drill holes
@stephenbeasley33311 ай бұрын
Why would you buy the harness and still use junk scotch locks? If you would have bought the correct terminals for the the switch on the winch controller it would have plugged right into the new harness. Stay away from scotch locks, that junk will leave you stuck in the woods.
@r3tr01022 жыл бұрын
Using wire harness sets it up for the 12volt plug in , installation. Go look at Arizona Kid channel for video