Banshee Misfire-Bog-Cold Pipe Right side.

haveing truoble with my Shee i cant get it to work fine, carbs are sync, 27.5 pilots. 280 jets. air/fuel screw 1 1/2 turns out. ToomeyT5 pipes. "New"Black Box CID."New"K&N filter NO air box. "New" Coil. "New" Stator. TORNS removed.Castor 927 32:1."New"Wiseco Pistons 64.5. Cylinder Bore to 64.5..basically new top end you can say..Compression 120 on each cylinder... i also switch the plug wires and same thing.

[@sarahhodges9862]

had same issue adjust the needles in your slides usually runs best on the #3 - #4 notch.. clean carbs real good. make sure your slides when installed in your carbs have the half moon shaped facing out towards your airbox! NO FLAT BOTTOMING OUT!! sync carbs by the adjusters on your cables..also make sure your slide guides (little nipples in your carb are pushed in to guide your slide up and down and not let them spin). your banshee sounded exzactly like mine.. took some time to figure it out after much trouble shooting and time!

[@Akronosis]

no, it wasnt anything with the slide, needle or any of the common sythoms. my left carb wasn't working " i bought another set for 100$ almost new. and the BOG the way to fix it is by screwing IN your itle screw. now my SHEE runs AWSOME.

[@Akronosis]

feli lira right carb *

[@Sketch1994]

Check the ignition timing for each cylinder seperately.

[@speedyloke48]

My banshee was misfiring on the right side, I cleaned carbs n jets, replaced plugs. Found out there was a hose connected to both carbs In between them, it had a hole. I replaced n ran normal.

[@simonkash6571]

i know I am kind of off topic but do anyone know of a good website to watch new movies online ?

[@curtisrobert2519]

@Simon Kash I watch on Flixzone. You can find it on google :)

[@geraldmathew3501]

@Simon Kash lately I have been using FlixZone. You can find it on google :)

[@bamagolds]

Hey, I'm seriously thinking of replacing my stock 34mm PJ carb with a 35mm Air Striker. I only have one carb on my trx250r and recognize that sound well. Instead of listing all I've done, here's what I haven't: Replaced the carb, stator and amature, and CDI. The stator reading is within specs. When I replaced the coil, I did have stronger fire, but still runs poor and fouls plugs fast. Would you replace the carb? thanks

[@thomashamelin7739]

Just make sure you get the original the Chinese copy is not worth shit if you are short on cash just go with a use one

[@daveerin3518]

Looks like u are missing the choke tube connecting the carbs together.

[@TheCapTan]

Need your help. I recently got a banshee and needed to rejett it and see what's jets were in it. I went 1 clip down to 2nd and now my right cylinder is backfiring with sparks and running cooler with less smoke. I've messed with air screws and that didn't help. Was running fine before rejett except being really rich.

[@Akronosis]

rejjeting.. it all come on what you have,or if you have added any aftermarket parts,pipes,carbs,reed, ect.. first try putting back your needle clip back to were it was.and if the problem still the same, the chances are that your air screw will be the problem. adjust one carb at a time.. count your turns. both carbs dont have to be on the same amount of turns for the bike to run good.

[@rednecklife-uu3je]

From reading your desc all that is really left to do is to check your reeds/cage intake boots for air leaks.

[@Akronosis]

thanks, but the problem was my left carb.

[@Akronosis]

feli lira Right Carb.. Sorry*

[@rednecklife-uu3je]

feli lira Clogged? wrong jets or??

[@Akronosis]

redneck4life887 no, was my right carb. ive fix the problem just that i havent uploand a video about it but soon i will, also another video how to install a battery on it.

[@rednecklife-uu3je]

feli lira Yea i know right carb, thats why i asked wrong jets or clogged carb?

[@bobbyhamilton7751]

Your crankshaft may be out of phase. Mine had the same problem and I tried everything to do with carbs and nothing fixed it. This is because the left cylinder is on the stator/timing side and the right isn't so the right side piston isn't in position for combustion when the plug is sparking causing the unburnt fuel you see on the floor . If you also have extreme vibration this is definitely your problem.

[@juliochavez3872]

bobby hamilton wat did u do to fix ur problem

[@josephjohnson9337]

bobby hamilton what do you do to fix it

[@TheRealkillpr]

0

[@coyoterob2839]

My banshee throughs out more smoke on the right pipe but it’s the colder pipe, and the left throughs very little smoke but it the hotter one, help???

[@monstermisfits666]

Same problems but the hot pipe run good and cold pipe miss fire

[@imortalaztec]

What did you end up doing? I got same problem I'm about to do a carb rebuilt

[@bansheebuildstv123]

I got the same problem with mine and can’t figure it out help!?

[@coyoterob2839]

I would try to get ur carbs linked together, so like pull the airbox off and see if the carbs are synced together and have the same amount of gap on both side when idle and giving gas or check spark on the bike

[@kellylane6522]

We just had this same problem trust me before you spend stupid money trying to narrow everything down. Check your jetting first our was jetted too fat so fuel was just dumping into the one cylinder before it had a chance to fire so we re jetted it and now running great.

[@Akronosis]

Problem solved, on of the carbs had and extral hole, patched with a screw and tefflon so extral air was coming into the carb.

[@coyoterob2839]

Mine runs good at idle, but the left pipe is hotter then the left n the left pipe throws out less smoke then the right. Is this the same issue? You jus fr jetted it and put new jets in, like the main pilot or what?

[@Justandjust.]

@@Akronosis helho, I have a same problem. kzbin.info/www/bejne/Z36ZZ5V4fZ18i7c

[@jamesdeanvegas]

Clogged jets

[@steveringer7143]

Its the carb. No smoke means no fuel.

[@Albalash97]

Steve Ringer are you sure because my left pipe doesnt smoke when i pull the choke its smoke

[@steveringer7143]

Fadhel Albloushi is the dead cylinder firing? if it is then its not getting fuel and by leaving it running u probably destroyed ur motor. No fuel means no oil

[@Albalash97]

Steve Ringer inside the carb when i press gas its blown gas in carb and the cylinder get hot not dead

[@Albalash97]

Steve Ringer but when press gas there are no power and turn off

[@countryboy5286]

is that a boost bottle you're running and does it give it more hp was thinking of getting one

[@Akronosis]

donnie willis No My Friend it doesn't do anything in my Opinion. I replaced it for the Stock Tube.

[@countryboy5286]

Mr. Elf ok thanks bro.

[@joeneault785]

yammy claims it helps with the bottom end..my 2000 banshee is just running the stock tube too.

[@dadsontrucking9848]

Your slides could be out of wack

[@OGKILLa9365]

Try new reeds

[@EnjoySk8ter69]

slides arent sinced

[@Akronosis]

yeah, they are.

[@EnjoySk8ter69]

reeds good? maybe one pipe is a liittle clogged

[@Akronosis]

yeah, i believe are the reeds since i took everything aprart to check my pisotons rings ect also to replace my gaskets since MY dum ASS put the old ones by aiccident but gaskets werent the problem.. Reeds are im 99.9% sure since i switch them and now my right pipe kick like a mada F... and left side is bad as when my righ side was.. so reed must be replce.

[@dadsontrucking9848]

Why put a cid on a high reving bike like the shee it’s just rev Suicide anyway sounds like your sucking in air from somewhere not good

[@MichaelWilliams-kt4wl]

it's your piston ring mines did the same thing and replaced it and runs like new

[@Akronosis]

Its was the One of the Carbs i fix that issue. Now ive move out of state, and having this other problem. Bike idles Awsome but once On gear it doent rev all the way so i have to gear up. Lets say you can rev to 10rms max but on gear ican only go up to 5rpms, then am force to gear up.

[@randomguy93984]

Mr. Elf that happened to me. my choke like was stuck and kinked so the choke was on full. it freaked me out because i went through literally everything and then i saw the choke and popped jt back and now bam. perfect

[@CesarRamirez-we1cc]

So what was the problem? I'm having the same issue and don't want to buy something it doesn't need

[@Akronosis]

the problem was my right carb.. i guess the prebious owner made an extra hole, when he removed the torn system. i try patching the hole with many things but the problem was still there, till i decide to be another pare of carbs. and since then my SHEE has never gave me any problems again..

[@Akronosis]

feli lira another thing you can do which I also did was, switch the carbs left side to right side And Right to left.. this way you can see if the problem happens to the other side.. since the carbs are going to be switch. if the one side that was bad when the carbs were in there original place starts doing the samething now that there are switch, then you will know its the carb or something inside the carb.

[@CesarRamirez-we1cc]

feli lira Thanks for the response. i figured my problem, after taking both my carbs apart several times i noticed my right carb wasn't getting any gas every time i took them apart the right one was always dry so i adjusted the floats and replaced the plunger... put it back together and started in one kick idling great with no bog

[@Akronosis]

thats great man.... glad you fixed you problem..

[@stevesirak]

Crank seal is bad and sucking in transmission oil

[@stevesirak]

99% sure do a leak down test

[@banshee100]

Did you ever figure this out

[@Akronosis]

Yes.. Bad Carburator!

[@Ito253047]

So you just replace the carburetor I am having this trouble sometimes in the left side one

[@hamdanalblushi6935]

Can u help me I got the same problem on my banshee one header is cold and the other is hot

[@Akronosis]

if your having the same problem. its your Carburator, from the side that its not getting hot. the best way to know if its the carburator swith them. you will just need longer tubes"hose", that connect both of the carbs.or check if the carb from the side that its not getting hot has an extra hole beside the idle screw if you remove the TORNS. . if anything Email me.

[@derekherndon1013]

feli lira my babshee is doing the same, only one muffeler is hot and I've tried everything, please help [e-mail]

[@Akronosis]

Check the carburator from the side that its not getting Hot Thats was my problem It had an extral hole drilled..

[@Troublegsxr]

+hamdan alblushi I had the same problem and my jets were to small

[@jonathanstone1252]

Mr. Elf did you ever figure out what was wrong with it because I am now experiencing the same thing where on my clutch side which would be the left side the pipe is cold but on the hand brake front brakes side the pipe is hot and it is doing the same exact thing what did you do to fix this I’ve clean the carbs and it actually runs worse now please help with any information you have 17072966824

[@joeneault785]

1 1/2 turns out???? you dont know how to count,you turned it basically 4 times,the effective range is 2 not 4 lol

[@ethanmcallister1748]

Time for a rebuild, dude