Barrel Chair 2.

[@Misschickchicky]

Just what I was looking for. Thank you. Please hurry with #3.

[@andrewparker6019]

It is easier if you can purchase a barrel, because the hoop marks and stave curviture will be the same. You can get by purchasing individual stave,however if you can't select them your self and you just get camp run you may have difficulty getting good matches fo the back, arms and seat wheich require the most consitancy. I hope this helps, if you have any other question please feel free to email me again

[@andrewparker6019]

I usually by several barrel ast a time and then sort them based on width, curve and hoop marks. I hope this helps Andrew

[@andrewparker6019]

I will usually agree in fact the only thing I normaly refer to plans on are chair. and even that can be fudged once you know your seat height, seat depth and angle of the back.

[@752bikingfool]

do I need to purchase a whole barrel for consistency or can I purchase staves already broken down from a barrel form

[@imawoodgrain]

Plans? We don't need no stinkin' plans! LOL

[@gregadams549]

GREAT VIDEO, Where do the different sized staves come from ? Im looking for the wide ones for the arms ect.

[@fci83esp97]

I'm finally beginning to construct the chair. What size wood plug did you use to extract the plugs??

[@fci83esp97]

I'm in the process of constructing the chair. The plans call for 20 inch front legs, you call "braces". The pieces you cut seem to be much larger than 20", especially after you measured 13" from the bottom of each leg. Can you verify what size did you cut your legs?

[@dmoss8928]

Did you ever find out the lenght of the front legs?

[@adampowers9639]

What kind of bit did you use for the plugs ?

[@daddywoofdawg]

if you used a spring clamp on the end of your tape you don't have to fight it jumping off.any sources for getting barrels?where can i get the plans?

[@robertcornelius3514]

My only improvement would be to upgrade the size of screw from a #8 to a much stronger #10.

[@jonharvey4522]

the plans call for #6 but I am using #8 which seem perfect

[@arlettearriaga5388]

Hi mr Parker, what is the length of the “H” legs

[@luanpham7469]

Mine is 24"

[@christinalazo8607]

What is the length of the front two legs ?

[@dmoss8928]

Did you ever find the answer to this?

[@jhifishhead]

How many barrels per chair?

[@luanpham7469]

One barrell can made one chair and two round table.

[@somebarrel]

oh its me

[@FLHawk]

Andrew, plans call for legs to be 20" long. Yours seem longer?? Did you deviate from the plan?? How long are your front legs, thanks!!!

[@MenagerieBocceVenue]

my plans state 23"

[@dmoss8928]

@@MenagerieBocceVenue so the front legs are 23 inches long?