Basic Commercial Installation With TPO

Рет қаралды 40,465

Күн бұрын

Пікірлер: 43

@BigWillieD_VIXI 3 жыл бұрын

Great video and very informative. This kind of info is what separates the big dogs from the little ones on the porch. Nice work!

@Sle3p520 2 жыл бұрын

Nice video bro, I’m excited to start commercial roofing in July!

@TXROOFING 2 жыл бұрын

Don’t forget your shades the white roofs are extremely reflective.

@G82M4RC 2 жыл бұрын

good luck lol

@richardramirez2319 4 ай бұрын

Hows it going bro? Im bouta start again

@skrawny-clown-snatcherofth8651 Жыл бұрын

I work for a company in the PNW that IS the biggest buyer and installer of J&M material in the entire USA and let's just say I went from pipeline welding in texas to industrial roofing in Washington and Oregon and I love it so much

@bighowdy60 11 ай бұрын

Whatcompany do you work for?

@bdeceo2720 11 ай бұрын

We probably work for the same company who?

@jorgemendoza3227 8 ай бұрын

How much they is the pay

@alvarorobles17 2 жыл бұрын

Safety is top concern? Where is your fall protection or safety flags?

@TXROOFING 2 жыл бұрын

We just got on the roof that morning and haven’t set up the poles and flags so we could film that really quick. Then we actually started working instead of doing the demonstration.

@gaisee 3 жыл бұрын

This is great to see! Great job!

@jorgelawes Жыл бұрын

“Safety is a top concern”, says the guy in shorts, tennis shoes, and no PPE.

@davidohlhaut3927 2 жыл бұрын

How did this guy find time to get on a roof between sets at the gym??

@TXROOFING 2 жыл бұрын

Hahahahaa gym is everyday after roofing, work always comes first.

@markv151 Жыл бұрын

Says safety is top concern, then video cuts to him about 2 feet from roof edge with no fall protection in place ! 0:50

@sigmadads9818 2 жыл бұрын

Does a contractor need to have a special, or specific, license to install TPO?

@elijahdavidson486 2 жыл бұрын

@skrawny-clown-snatcherofth8651 Жыл бұрын

No but I will tell you from experience keep the stuff clean and don't skimp of seam cleaner since the cleaner the better the welds will be

@Saul-k1e 7 ай бұрын

how many reps do you guys have to do if the roof leaks? (serious question)

@roblongoria1709 Жыл бұрын

is the tpo not glued down? only heat welded at seams?

@SpidermansSymbiote 15 күн бұрын

"Safety is a top concern" proceeds to stand a couple feet from the edge of the roof with no fall protection.

@dustinmeek4032 3 ай бұрын

I don't like densdeck for mechanically fastened.

@rainydaysroofer9474 3 ай бұрын

No perimeter fence and no safety harness.

@evanlovesbears 2 жыл бұрын

Shirts way too clean, get back in the office holmes.

@TXROOFING 2 жыл бұрын

I try and have clean clothes on daily as a part of general cleanliness 👌🏼

@msnzbody3712 Жыл бұрын

All these white guy roofer charge way to much and they end up just using mexicans to do it anyway while the sit in the office.

@russellames9420 2 жыл бұрын

How do you flash around a chimney with TPO. There the roof is 1/12 pitch

@juniormiller1649 2 жыл бұрын

Run your TPO to the base of chimney and use seam plates at base 12" OC. Measure and cut TPO flashing to go around chimney. I believe the tpo typically must go up at least 8". Use adhesive on wall of chimney, heat weld the base and then use term bar and water block to properly terminate it at the top. This is for a non- high temperature stack, such as a typical brick or wood surface. Heat weld universal corners to finish it. You can also use detailing membrane for your flashing but it won't have the same strength.