Basic concept of condition-based monitoring with an AC drive explained

[@aryansharma9861]

which vibrational sensor do you use?

[@danfossdrives]

Hi Aryan, For this particular video, we used a velocity transmitter. In general, CBM can monitor up to 4 external analog sensor signals simultaneously - on top of the internal signals that CBM is monitoring. In addition, when it comes to vibration, we normally use two different type of sensors for different fault detection. These are: Vibration RMS : velocity transmitter 4-20mA Vibration GPEAK: accelerometer 4-20mA And we recommend and sell sensors from Hansford Sensors. I hope this helps you. Kind regards Danfoss Drives Social Media Team

[@peggysoriano3626]

@@danfossdrives What is the part number of the velocity transmitter? Where do we buy one?

[@danfossdrives]

Hi Peggy, The sensors can be ordered from Danfoss or Hansford Sensors. To make it a bit easier for you, you can see the ordering numbers below here: Transducer 0-10g, 4-20mA • Danfoss ordering number: 134B8492 • Hansford Sensors number: HS-D22B10 Transducer 0-25mm/s, 4-20mA, RMS • Danfoss ordering number: 134B8493 • Hansford Sensors number: HS-D20C0255019 Transducer 0-25mm/s, 4-20mA, RMS, with temperature PT100 • Danfoss ordering number: 134B8494 • Hansford Sensors number: HS-D20CRT0255408 Cable 10m for 8492 and 8493 • Danfoss ordering number: 134B8496 • Hansford Sensors number: HS-AC334-10 Cable 10m for 8494 • Danfoss ordering number: 134B8497 • Hansford Sensors number: HS-AC010-10 Hope this helps you! Kind regards Danfoss Drives Social Media Team