Why not build ethercat standards like EthernetIP 😏 without us buying Si-EtherCat module.
@ricke8826 Жыл бұрын
I'm using a M701 with SI-Ethernet module and controller is EXL10 unable to communicate between units,ideas.
@justinpuzak2558 Жыл бұрын
Can you use a selector switch to one of the inputs to change start & speed source. Like this. 1= (I’m getting my Speed & start signals from PLC “Ethernet IP”) And then 0= (I’m getting my speed & start signals from the embedded IO) I do this with powerflex sometimes, you can have 3 different start and speed selections programmed. you can send a signal to one of digital inputs to change which start & speed source you want at that time. Is this possible with the unidrives. ?
@vorapobautomation97602 жыл бұрын
Dear Sir, I would like to know the command to jog M702 drive from PLC. Which bits in control word should be "1" ? Best Regards, Vorapob
@nidecdrives-us2 жыл бұрын
Please submit a support ticket for assistance. You can do this from our Support page: acim.nidec.com/en-us/drives/control-techniques/service-and-support/technical-support
@seimela2 жыл бұрын
I have a ticket which will soon expire because they haven't replied to it
@vorapobautomation97602 жыл бұрын
@@seimelaHow to they will reply it please ?
@seimela2 жыл бұрын
@@vorapobautomation9760 they never replied
@miguelzavaleta93912 жыл бұрын
You can use bit #2 of the control word (0.06.042) if you've set that up as one of your "expected" output words on parameter 4.22.0XX.