Basic Fundamentals of Geotechnical Engineering- USCS Classification System [Tagalog]

[@russelllloydsantos3329]

thank you po sir malaking tulong po

[@nertoriko3092]

Hello po sir. tanong ko lang po 1. Cc < 1 or Cc > 3. it means po na below 1 but less than 3, not between 1 and 3. so dyan pa rin po ba siya ma belong? 2. PI > 7 and plots on or above A line. While PI is indeed greater than 7, however, it does not plot above on the A line. any points on this po? thank you

[@rayosalissajaner.2675]

Yung formula po na sa gravel na 100% kasama po talaga sya sa formula O mawawala po yan kung di kasali yung sieve 1/2

[@TEMELTASCONSTRUCTION]

good job

[@ruelramosjr.9492]

Sir good day, what will happen if the %gravel and %sand is less than 50%? Kasi sa sinolve ko po, my %fines is 30, %gravel=30, %sand=40. LL=3, PL=21. Thank you po

[@edbertpajarito3345]

Good day po sir, matanong ko lang po kung ang pagkuha ng D10, D30 and D60 ay only estimation between ng dalawang sieve sizes? Thanks po sa pag answer :)

[@cecornertv1077]

Yes sir. Estimate in a way na dapat gumamit po tayo ng ruler sir. I suggest, divide nyo sa 10 equal size yung spaces between sieves size para mas accurate po ang result. And use separate sheet for plotting the curve. Thank you.

[@Hapon1996]

Pano po nakuha yung D60 =0.45mm

[@davearcega5906]

Sir may content po kayo about Soil classification using USDA po ? Thank you po .

[@cecornertv1077]

next week po mag upload na ulit ako. Thanks

[@JLeeDags]

Sa base on graph sir. D ko masyado na gets kung pano pag convert nung kanyang diameter😅 paano po ba sir?😅

[@adrianguirit3294]

Ano po bang book ang gamit nyo sir at sino author? Thank you

[@cecornertv1077]

Fundamentals of Geotechnical Engineering and Foundation Engineering both by Braja M. Das.

[@adrianguirit3294]

Thank you Engineer