Рет қаралды 513
For project Quasi-Z-source inverter (qZSI) is an experiment following the previous Z-source inverter (ZSI) to study and try this circuit. The experiment is divided into 3 parts: 1. Start-up to get the rated output voltage (Setpoint 25V) 2. Power supply to the load at approximately 30 watts and observe the Vgs signal that responds Per load 3.Circuit overcurrent protection. Experiments of Quasi-Z-source Inverter The circuitry provides similar performance to that of a Z-source inverter, but is easy to implement because it uses a single ground reference point.
*Information
1. Vinput : 13.8V/5A
2. Voutput : 25V (Setpoint)
3. Iout: 1.22A (Continuous)
4. Efficiency estimate : 75%
5. Frequency switching : 50kHz
6. Power MOSFET : IRF3205
7. Control board : Arduino UNO
8. R Load :10 Ohm/20W x2
*Website : www.electronic...
*Reference
1. www.slideshare...
2. www.researchga...
3. www.oreilly.co...
4. www.researchga...
5. www.researchga...
#Quasi_Z_source_inverter
#Arduino_UNO
#DC_to_DC