I did hotplate reflow for couple years , used an inexpensive controller from sparkfun so that I could use the reflow profiles. Worked ok but really wanted to reflow double sided pcbs . So converted a toaster oven to a reflow oven that utilizes a pid controller . Superb results .
@campbellmorrison85403 ай бұрын
Interesting method, I think your solder paste volume was a bit excessive and should be a little more accurate to be honest but it looks like it works well for a few chips but I would personally use a mask for a reasonable number of devices on it as having to go around and clean up each device wouldn't be that practical in my opinion.
@1kreature3 ай бұрын
This basically shows that you can do pretty much everything wrong and still get good results by cleaning up in the end. SMD is a lot more forgiving than people think. The flux and surface tension of the solder does most of the work.
@campbellmorrison85403 ай бұрын
@@1kreature Totally agree, that flux is quite amazing stuff