BC Racing Coilover Installation - 90-97 Honda Accord

[@jerseylife8701]

Best video on coilovers for an accord ever. my grandma gave me her 96 lx with 16,000 miles on it like 7 years ago. shes got 110k now but shes all oem except a few things. I switched out the knuckles for 98 acura rotor over hub design and now i want coilovers and new tie rods bushings control arms etc to get rid of the nasty body roll.

[@canadianbluepants9446]

i cant believe i have just found you, i bought a cb9 a few weeks ago as my first car and ive been wondering how to do this and that and you have the answers to all of it, amazing (i may also be jealous of that blue since cb9s are super rare here)

[@Gabe-tt2jj]

your awesome man, you give me lots of inspiration for my own accord. Much love from Jersey

[@georgenaranjo8852]

Love the videos! Can't wait to see how this thing turns out. Happy holidays!

[@norm5431]

Thank you for this vid. This is what I needed to refresh my mind. My TEIN’s were leaking and would not pass a “safety check” 🙃 Very good video👏🏽👏🏽👏🏽👏🏽🤙🏽🍍🍍🍍🍍

[@overwatch1385]

I reviewed your video prior to lowering my cb7 coupe. Thank you 👍👍

[@_20nine_]

Getting my 92' LX coupe back up and running, thanks for the help bro

[@andycandy7747]

Great video

[@CALLIN799]

Like the accord! 5 lug that's awesome!

[@seanrose3951]

This rules!!

[@Rogg33k]

Awesome thank you best video

[@accord_aero_r]

Did you use anti-seize putting that rear lower strut bolt back in? I'd do that on all exterior bolts, but the rear suspension bolts in particular seem to be super susceptible to rust. Both my toe bolts and my lower strut bolts had to be cut off of my car because they were seized into the bushing sleeves. I was so jealous to see yours zipped right out when taking out the stock struts. Can't wait to see this on the ground with the wheels!

[@randomrebuilds]

No but guess it wouldn’t hurt to do so. Fortunately this is a FL car so rust hasn’t been an issue for me.

[@IsaacSanchez-y4j]

I have a question i was wondering what kind of rear upper control arm you have i have a 1990 honda accord cb7 and the rear upper control arm slapped in half my car is low and im not sure what kind to buy

[@randomrebuilds]

@@IsaacSanchez-y4j I installed SPC rear adjustable UCAs. Part #67265

[@machocalderon4042]

Nice job made it look eze

[@vintagegear5240]

Honda told me that the car is too old and they might not be able to diagnose/ fix my issue. My car leans to the driver side by an inch . What’s your opinion on that? It also made metal riddle noises as I went up slopes. I put air into it and I don’t hear the rattling anymore much but it leans

[@randomrebuilds]

The driver front side leans more than the passenger front due to the engine weight and placement being heavier towards the drivers side. Coilovers with height adjusted or pre-load adjustment will fix that issue and level the car out with your settings.

[@vintagegear5240]

@@randomrebuilds I weigh 250 lbs. what are the odds that my fat is causing the issue? There are times that I guess that I have just noticed it blatantly . Would the coilovers and height adjustment be able to be done to factory spec? Are coilovers a replacement for the spring? So the whole cylinder/vertical rod/ spring /strut , whatever you’d call it would need to be replaced ? Also curious on the likelihood of finding the right sized coilovers if it is possible for an older car

[@isaihsalas7412]

Is that an f20c? If so that's sick af!

[@randomrebuilds]

H22A

[@isaihsalas7412]

@@randomrebuilds ok ok under appreciated engine! I kike it!

[@gabe70hb]

Doing the lords work! I went with the same coilovers, but opted for the regular springs. Also in the process of gathering all the parts to 5 speed swap on my 91 CB7. What did you set your dampening to? I set mine halfway between hard/soft for now, but noticed the rear is bouncing a little bit more

[@trackshun]

In my experience on the CB7 and my FG4, I would set my rears to hogher dampening than the front. The stiffer the rear is on a fwd, the better for overall handling. I’ve tried it the other way around, I’ve tried front and rear at 16 on a 32 & 33 way adjustable, the car just oversteers. So set rear to more damp than the front. And gradually drive and test your car to set it just right.

[@rutenmedita4686]

Can't wait to see the wheels. Got same car sedan

[@Miguel-dl3pp]

do the coils still fit after doing a 5lug swap using the ody knuckles upfront

[@trackshun]

Coilovers are connected to the lower control arms. They fit no issue.

[@Miguel-dl3pp]

@@trackshunthanks havent even done the swap yet

[@doclockwood8809]

Great videos. Any videos on how to service/urethane fill/fix/replace the rear engine mount on my '92 Cb9? Thanks, and happy holidaze! Hondas Rule!

[@pedrososa26]

How low is the front bro ?

[@ZacVaper]

Pictures of the cars on it's wheels, before and after, would have been the thing to do....