BCM Pre-Terminated Leads / Pinning your BCM

[@richardleslie410]

Thank you sooo much for this video, after hours for fussing with inserting a pin into the BCM connector I almost gave up until I saw your video. Thank you!

[@JoseOrtiz-pk6ty]

Do you have any harness to put a heated and cooled seat

[@gerardoalcazar4997]

I know it’s an old video but hoping you’ll see and have some insight, is there any male connector for this?

[@scottstamm7022]

Vehicle - 2022 (technically 2021) Silverado Custom Wiring Question - I want to go to the 8" screen and controls from the 7" screen and controls. 1) Yes/No - Could I take the two different wire connections, and rewire these two connections together, to get the 8" screen to work with the 7" screen controller? 2) If 'No' above - can I have my BCM programmed to take the different control module for the 8" screen, and the other connections, are they pinned the same so it would be a swap and go for everything else? Thanks for your time.

[@skubasteve5081]

Phi the connectors that your using are the same as the door connectors ? If so would you sell some ? I trying to do the Cadillac door handles on my 2017 Silverado

[@LjsAdventures1216]

What’s the terminal pin size for the jst plug ?

[@LarryStetz]

How do you remove connector from the BCM?

[@jordankennedy6759]

any idea where i could buy a single connector (reasonable quality) ? I.e the green one? Thanks

[@philgamboa2906]

Just the bare connector? How many?

[@fredjones5327]

Great video can I have a link for the slim tool?? Please and thanks

[@philgamboa2906]

Just posted the link in the description.

[@fredjones5327]

@@philgamboa2906 thank you!!

[@fredjones5327]

@@philgamboa2906 can you create or construct a VW harness???

[@philgamboa2906]

@@fredjones5327 Unfortunately, no. Most of my work if around the 2014+ GM Trucks.

[@fredjones5327]

@@philgamboa2906 gotcha thanks for this video again!!!

[@JohnAnnarella-xe1cy]

Trying to get in touch with you about a different situation

[@philgamboa2906]

Reach me at HarnessDR.com

[@jimmyteter]

Any new videos coming soon?

[@philgamboa2906]

Yes sir. Stay tuned. Been super busy with backlog orders but have some videos to edit and upload :)

[@jimmyteter]

@@philgamboa2906 Ahh yeah, thanks!!